Search results
Results from the WOW.Com Content Network
The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles. Additionally, GM incorporates a vibration damper on the yoke, while Dodge positions it on the drive shaft.
A face gear set typically consists of a disk-shaped gear, grooved on at least one face, in combination with a spur, helical, or conical pinion. A face gear has a planar pitch surface and a planar root surface, both of which are perpendicular to the axis of rotation. [1]
GM discontinues Tracker including ZR2 model. 2005 - This is the last year for the ZR2 Blazer (USA) and Jimmy (Canada) GM discontinues all remaining S-Series models. RPO ZR2 is phased out. 2017 - GM reintroduces the ZR2 option on the Chevrolet Colorado. 2022 - GM introduces the ZR2 option on the Chevrolet Silverado 1500.
The General Motors Automatic Safety Transmission (AST) was a semi-automatic transmission released in 1937. The first mass-produced fully-automatic transmission developed for passenger automobile use was the GM Hydra-Matic introduced in the autumn of 1939 as a (very likely subsidized) $57 option for the 1940 Oldsmobile. [1]
The first Dana 70 axles had a 1 ⁄ 2-inch (13 mm) pinion offset and were found in Dana 70HD's as well. The drawback with the 1 / 2-inch offset was that a 4.10:1 gear ratio was the highest gear set possible. In the 1970s the 1 / 2-inch offset was phased out for a 5 ⁄ 8-inch (16 mm) offset that allowed
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
The complete configuration of a GM vehicle (as it exited the factory) can be described by specifying the base model and a complete list of its RPO codes. [1] Some dealerships are willing to run a VIN and print out its RPOs (with their definitions) free of charge. The records are in GMs' electronic database since at least the 1990 models.
Starter ring gear attached to a flywheel. In cars with a manual transmission, the starter ring gear is fitted to the outer diameter of the flywheel.The ring gear is usually fixed to the flywheel through use of an interference fit, [2] which is achieved by heating the ring gear and so that thermal expansion allows it to be placed around the flywheel.