enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Automotive lighting - Wikipedia

   en.wikipedia.org/wiki/Automotive_lighting

   The incandescent light bulb was for a long time the only light source used in automotive lighting. Incandescent bulbs are still commonly used in turn signals to stop hyper-flashing of the turn signal flashers. Many types of bulbs have been used. Standardized type numbers are used by manufacturers to identify bulbs with the same specifications.

3. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   An older, but still widely used, high-leg delta system uses three phases with 240 volts phase-to-phase for motor loads, and 120 volts for lighting loads by use of a center-tapped transformer; two of the phases are 120 volts to neutral. The third phase, the "high leg" of the system (also referred to as the "wild leg"), has 208 V to neutral and ...

4. Automobile auxiliary power outlet - Wikipedia

   en.wikipedia.org/wiki/Automobile_auxiliary_power...

   For the 12 volt systems, the center contact is the positive terminal and the shell is the negative terminal. Most automobiles connect the negative terminal to the frame of the vehicle (negative ground). 12 volt auto connectors are made to comply with a standard by Underwriters Laboratories for safety. UL2089 was developed to cover the ...

5. DIN 72552 - Wikipedia

   en.wikipedia.org/wiki/DIN_72552

   charge indicator (charge control light) B+ battery + 51, 51B+, B+30, B+51 B- battery - 31B- D+ dynamo/alternator diode+ D- dynamo/alternator diode- DF dynamo field DF1 dynamo field 1 DF2 dynamo field 2 U, V, W AC three phase terminals Lights 54 brake lights 54g lights 54 55 fog light N 56 spot light 56a headlamp high beam and indicator light 56b

6. Trailer connectors in North America - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   If you have a trailer with a lot of lights the diode and relay wiring is preferred, but if you have a trailer with a simple light arrangement it is usually sufficient to wire to 58L. In market there are many special converters [ 1 ] [ 2 ] [ 3 ] that solves the problem of connecting a car with European wiring to a trailer with North American wiring.

7. LED circuit - Wikipedia

   en.wikipedia.org/wiki/LED_circuit

   Simple LED (Light Emitting Diode) circuit diagram. In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED.