enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Light switch - Wikipedia

   en.wikipedia.org/wiki/Light_switch

   In electrical wiring, a light switch is a switch most commonly used to operate electric lights, ... Illuminated switches incorporate a small neon lamp or LED ...

3. LED circuit - Wikipedia

   en.wikipedia.org/wiki/LED_circuit

   Simple LED (Light Emitting Diode) circuit diagram. In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED.

4. Multiway switching - Wikipedia

   en.wikipedia.org/wiki/Multiway_switching

   In building wiring, multiway switching is the interconnection of two or more electrical switches to control an electrical load from more than one location.A common application is in lighting, where it allows the control of lamps from multiple locations, for example in a hallway, stairwell, or large room.

5. Electrical wiring - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring

   Electrical symbols for wiring [vague]. Electrical wiring is an electrical installation of cabling and associated devices such as switches, distribution boards, sockets, and light fittings in a structure.

6. 3-way lamp - Wikipedia

   en.wikipedia.org/wiki/3-way_lamp

   A 3-way lamp, also known as a tri-light, is a lamp that uses a 3-way light bulb to produce three levels of light in a low-medium-high configuration. A 3-way lamp requires a 3-way bulb and socket, and a 3-way switch. In 3-way incandescent light bulbs, each of the filaments operates at full voltage. Lamp bulbs with dual carbon filaments were ...

7. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking with ridged, grooves or white stripes on the surface of lamp cord.