Search results
Results from the WOW.Com Content Network
When calculating volume requirements, one would begin by assessing the available space. Once length, width and height restrictions have been ascertained, the easiest method of determining volume is with the use of a truck tank volume calculator. Although basic mathematics can be applied to calculate the volume of a cylinder, calculating that of ...
Oil tankers generally have from 8 to 12 tanks. [1] Each tank is split into two or three independent compartments by fore-and-aft bulkheads. [1] The tanks are numbered with tank one being the forwardmost. Individual compartments are referred to by the tank number and the athwartships position, such as "one port", "three starboard", or "six ...
Mixed liquor suspended solids (MLSS) is the concentration of suspended solids, in an aeration tank during the activated sludge process, which occurs during the treatment of waste water. The units MLSS is primarily measured in milligram per litre (mg/L), but for activated sludge its mostly measured in gram per litre [g/L] which is equal to ...
P 2 and V 2 the initial pressure and volume of the other cylinder and P 3 is the equilibrium pressure. An example could be a 100-litre (internal volume) cylinder (V 1) pressurised to 200 bar (P 1) filling a 10-litre (internal volume) cylinder (V 2) which was unpressurised (P 2 = 1 bar) (resulting in both cylinder equalising to approximately 180 ...
Stack Tank Oil (STO) density (or API) may also be used by regulatory bodies to classify oil and oil products. Other properties such as Molecular Weight , saturated aromatic resin and asphaltene (SARA), refractive index , wax appearance temperature, asphaltene precipitation, and acid number , are also specified at Stock Tank conditions. [ 1 ]
Oil-in-place is also known as stock tank original oil-in-place (STOOIP) or stock tank oil-initially-in-place (STOIIP), referring to the oil in place before the commencement of production. In this case, stock tank barrels refers to the volume of oil after production, at surface pressure and temperature (as opposed to reservoir conditions).
Permeability of a space in a ship is the percentage of empty volume in that space. Permeability is used in ship survivability and damaged stability calculations in ship design. In this case, the permeability of a space is a percentage from 0 to 100. Alternately, the permeability may be a coefficient from 0 to 1. The permeability of a space is ...
A small amount of fuel in the tank leaves pumps on the floor of the tank exposed to the air-fuel mixture, and an electric pump is a potential ignition source. The explosion of a Thai Airways International Boeing 737 in 2001 and a Philippine Airlines 737 in 1990 also occurred in tanks that had a small amount of residual fuel. These three ...