enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Engineering fit - Wikipedia

    en.wikipedia.org/wiki/Engineering_fit

    Engineering fits are generally used as part of geometric dimensioning and tolerancing when a part or assembly is designed. In engineering terms, the "fit" is the clearance between two mating parts, and the size of this clearance determines whether the parts can, at one end of the spectrum, move or rotate independently from each other or, at the other end, are temporarily or permanently joined.

  3. Engineering tolerance - Wikipedia

    en.wikipedia.org/wiki/Engineering_tolerance

    For example, if a shaft with a nominal diameter of 10 mm is to have a sliding fit within a hole, the shaft might be specified with a tolerance range from 9.964 to 10 mm (i.e., a zero fundamental deviation, but a lower deviation of 0.036 mm) and the hole might be specified with a tolerance range from 10.04 mm to 10.076 mm (0.04 mm fundamental ...

  4. List of drill and tap sizes - Wikipedia

    en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

    Schematic of a machine tap. Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter.. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

  5. Geometric dimensioning and tolerancing - Wikipedia

    en.wikipedia.org/wiki/Geometric_dimensioning_and...

    Tolerances for the profile symbols are equal bilateral unless otherwise specified, and for the position symbol tolerances are always equal bilateral. For example, the position of a hole has a tolerance of .020 inches. This means the hole can move ±.010 inches, which is an equal bilateral tolerance.

  6. IT Grade - Wikipedia

    en.wikipedia.org/wiki/IT_Grade

    An IT grade is an internationally accepted code system for tolerances on linear dimensions. Such code systems may be used to produce interchangeable parts. In engineering, the word tolerance refers to a range of allowable dimensions or values. Standard tolerance grades are a group of tolerances for linear sizes characterized by a common identifier.

  7. Unified Thread Standard - Wikipedia

    en.wikipedia.org/wiki/Unified_Thread_Standard

    The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

  8. Drill bit sizes - Wikipedia

    en.wikipedia.org/wiki/Drill_bit_sizes

    ANSI B94.11M-1979 sets size standards for jobber-length straight-shank twist drill bits from 1/64 inch through 1 inch in 1/64 inch increments. For Morse taper -shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to ...

  9. Limits and fits - Wikipedia

    en.wikipedia.org/wiki/Limits_and_fits

    In mechanical engineering, limits and fits are a set of rules regarding the dimensions and tolerances of mating machined parts if they are to achieve the desired ease of assembly, and security after assembly - sliding fit, interference fit, rotating fit, non-sliding fit, loose fit, etc.