enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Jump start (vehicle) - Wikipedia

   en.wikipedia.org/wiki/Jump_start_(vehicle)

   A jumper cable connected to the positive (red) terminal. Jumper cables, also known as booster cables or jump leads, are a pair of insulated wires of sufficient capacity with alligator clips at each end to interconnect the disabled vehicle with an auxiliary source, such as another vehicle with the same system voltage or to another battery. The ...

3. Jump wire - Wikipedia

   en.wikipedia.org/wiki/Jump_wire

   Stranded 22AWG jump wires with solid tips. A jump wire (also known as jumper, jumper wire, DuPont wire) is an electrical wire, or group of them in a cable, with a connector or pin at each end (or sometimes without them – simply "tinned"), which is normally used to interconnect the components of a breadboard or other prototype or test circuit, internally or with other equipment or components ...

4. No One Around with Spare Jumper Cables? Keep One of These ...

   www.aol.com/lifestyle/editor-approved-portable...

   A07 Portable Jump Starter. For under $100, this portable jump starter is capable and reliable, reaching 1,500 peak amps, and powerful enough to start any vehicle with up to a seven-liter engine.

5. Jumper cable (disambiguation) - Wikipedia

   en.wikipedia.org/wiki/Jumper_cable_(disambiguation)

   Jumper cable may also refer to: Jump wire, a short electrical wire with a solid tip at each end used to interconnect the components in a breadboard; Jumper cable (vehicle), a pair of electrical cables used to jump start a vehicle; Jumper Cable, the 33rd book in the Xanth series by Piers Anthony; See also. Jumper (disambiguation)

6. Main distribution frame - Wikipedia

   en.wikipedia.org/wiki/Main_distribution_frame

   The MDF is a termination point within the local telephone exchange where exchange equipment and terminations of local loops are connected by jumper wires at the MDF. All cable copper pairs supplying services through user telephone lines are terminated at the MDF and distributed through the MDF to equipment within the local exchange e.g. repeaters and DSLAM.

7. Jumper (computing) - Wikipedia

   en.wikipedia.org/wiki/Jumper_(computing)

   Jumper pins (points to be connected by the jumper) are arranged in groups called jumper blocks, each group having at least one pair of contact points.An appropriately sized conductive sleeve itself called a jumper, or more technically, a shunt jumper, is slipped over the pins to complete the circuit.