enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...

3. Hex key - Wikipedia

   en.wikipedia.org/wiki/Hex_key

   Hex keys of various sizes with ball ends. Tamper-resistant hex screws have a protruding pin in the center of the hex recess that prevents insertion of standard hex keys; as such, they can only be fastened and removed with a special key that has a recess for the pin. A similar "center pin reject" security feature is also used on torx screws.

4. Hexadecimal - Wikipedia

   en.wikipedia.org/wiki/Hexadecimal

   Hexadecimal (also known as base-16 or simply hex) is a positional numeral system that represents numbers using a radix (base) of sixteen. Unlike the decimal system representing numbers using ten symbols, hexadecimal uses sixteen distinct symbols, most often the symbols "0"–"9" to represent values 0 to 9 and "A"–"F" to represent values from ten to fifteen.

5. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Schematic of a machine tap. Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter.. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

6. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   All three patterns may also be combined with a slot for a flat-blade screwdriver. Usually they are provided with a 1/4 in (0.25 inches (6.4 mm)) flanged hex head. Non-standard metricized 5.5 millimetres (0.22 in) flanged hex heads can also be encountered. Also common are pan head screws - a low disk with a chamfered outer edge.

7. Torx - Wikipedia

   en.wikipedia.org/wiki/Torx

   An External Torx version exists, also known as Inverted Torx, where the screw head has the shape of a Torx screwdriver bit, and a Torx socket is used to drive it. The external "E" Torx nominal sizing does not correlate to the "T" size, (e.g. an E40 socket is too large to fit a T40 Torx bit, while an E8 Torx socket will fit a T40 Torx bit [6]).