Search results
Results from the WOW.Com Content Network
where temperature T is in degrees Celsius (°C) and saturation vapor pressure P is in kilopascals (kPa). According to Monteith and Unsworth, "Values of saturation vapour pressure from Tetens' formula are within 1 Pa of exact values up to 35 °C." Murray (1967) provides Tetens' equation for temperatures below 0 °C: [3]
The saturation with respect to water cannot be measured much below –50 °C, so manufacturers should use one of the following expressions for calculating saturation vapour pressure relative to water at the lowest temperatures – Wexler (1976, 1977), [1] [2] reported by Flatau et al. (1992)., [3] Hyland and Wexler (1983) or Sonntag (1994 ...
The Köhler curve is the visual representation of the Köhler equation. It shows the saturation ratio – or the supersaturation = % – at which the droplet is in equilibrium with the environment over a range of droplet diameters. The exact shape of the curve is dependent upon the amount and composition of the solutes present in the atmosphere.
In the case of an equilibrium solid, such as a crystal, this can be defined as the pressure when the rate of sublimation of a solid matches the rate of deposition of its vapor phase. For most solids this pressure is very low, but some notable exceptions are naphthalene , dry ice (the vapor pressure of dry ice is 5.73 MPa (831 psi, 56.5 atm) at ...
The saturation vapor pressure is the pressure at which water vapor is in thermodynamic equilibrium with its condensed state. At pressures higher than saturation vapor pressure, water will condense , while at lower pressures it will evaporate or sublimate .
Lee [4] developed a modified form of the Antoine equation that allows for calculating vapor pressure across the entire temperature range using the acentric factor (𝜔) of a substance. The fundamental structure of the equation is based on the van der Waals equation and builds upon the findings of Wall [ 5 ] and Gutmann et al. [ 6 ] , who ...
To provide a rough example of how much pressure this is, to melt ice at −7 °C (the temperature many ice skating rinks are set at) would require balancing a small car (mass ~ 1000 kg [19]) on a thimble (area ~ 1 cm 2). This shows that ice skating cannot be simply explained by pressure-caused melting point depression, and in fact the mechanism ...
Red line shows saturation. The temperature at which dew forms on a clean surface is directly related to the vapor pressure of the air. Dew point hygrometers work by placing a mirror over a closed sample chamber. The mirror is cooled until the dew point temperature is measured by means of an optical sensor.