Search results
Results from the WOW.Com Content Network
In plumbing, a Fixture Unit (FU) or Drain Fixture Unit (DFU) is "a unit of measure, based on the rate of discharge, time of operation and frequency of use of a fixture, that expresses the hydraulic load imposed by that fixture on the sanitary plumbing installation". [1] A Fixture Unit is not a flow rate unit but a design factor.
DFU may refer to the following: Organizations. Dansk Folkepartis Ungdom, ... Drain fixture unit, a unit of measure in plumbing This page was last edited on 13 ...
A plumbing drawing, a type of technical drawing, shows the system of piping for fresh water going into the building and waste going out, both solid and liquid. It also includes fuel gas drawings. Mainly plumbing drawing consist of water supply system drawings, drainage system drawings, irrigation system drawings, storm water system drawings.
The IPC is the most widely used plumbing code in the United States and is also used as the basis for the plumbing code of several other countries [citation needed].Wide adoptions are important as they help reduce manufacturer and end-user costs by allowing the use of materials across a wide user base, thus allowing economies of scale in the production of materials used in construction.
The product of this effort, the first edition of the Uniform Plumbing Code (UPC) was officially adopted by the Western Plumbing Officials Association in 1945, which later changed its name to IAPMO in 1966 when the scope of the association’s work increased. The code has been widely used over the past five decades by jurisdictions throughout ...
Delta Faucet Company [1] is an American manufacturer of plumbing fixtures and plumbing materials. It is a subsidiary of Masco Corporation . It manufactures and markets faucets , kitchen sinks , bath/shower fixtures, and toilets under the Delta, Kraus, Peerless, and Brizo [ 2 ] brand names.
DePriester Charts provide an efficient method to find the vapor-liquid equilibrium ratios for different substances at different conditions of pressure and temperature. The original chart was put forth by C.L. DePriester in an article in Chemical Engineering Progress in 1953.
The set of terms below were proposed in 1949 by AB Bookman's Weekly.They were adopted by the bookselling community and are still in use today. [1] [2] [3]As new means that the book is in the state that it should have been in when it left the publisher.