Ads
related to: sata cables for power supplybhphotovideo.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
Power cable not shown. The earliest hard disk drive (HDD) interfaces were bit serial data interfaces that connected an HDD to a controller with two cables, one for control and one for data. [a] An additional cable was used for power, initially frequently AC but later usually connected directly to a DC power supply unit. The controller provided ...
eSATAp cables are available with wide connectors to plug directly into the power and signal connectors of a bare drive, providing a 12 V supply in the case of a desktop machine. A version of this wide connector is found inside every external SATA hard drive enclosure; when the hard drive is slid inside, it mates with a connector that supplies ...
Thus, the cables of a modular power supply must only be used with this particular modular power supply model. Usage with another modular power supply, even if the cable prima facie appear compatible, might result in a wrong pin assignment and thus can lead to damage of connected components by supplying 12V to a 5V or 3.3V pin. [34]
As SATA becomes more prevalent, Molex connectors can be found repurposed, through use of an adaptor, to serve as six-pin PCIe power connectors to make up for a lack of such connectors on a power supply. Lower power devices (e.g. 3.5-inch floppy drives) use the smaller AMP 171822-4 connector instead.
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
Ads
related to: sata cables for power supplybhphotovideo.com has been visited by 100K+ users in the past month