Search results
Results from the WOW.Com Content Network
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
The noise figure is the difference in decibel (dB) between the noise output of the actual receiver to the noise output of an "ideal" receiver with the same overall gain and bandwidth when the receivers are connected to matched sources at the standard noise temperature T 0 (usually 290 K).
A graph of the A-, B-, C- and D-weightings across the frequency range 10 Hz – 20 kHz Video illustrating A-weighting by analyzing a sine sweep (contains audio). A-weighting is a form of frequency weighting and the most commonly used of a family of curves defined in the International standard IEC 61672:2003 and various national standards relating to the measurement of sound pressure level. [1]
The day-night average sound level (Ldn or DNL) is the average noise level over a 24-hour period. The noise level measurements between the hours of 22:00 and 07:00 are artificially increased by 10 dB before averaging. This noise is weighted to take into account the decrease in community background noise of 10 dB during this period.
Multiple noise processes determine the noise floor of a system. Noise can be picked up from microphone self-noise, preamp noise, wiring and interconnection noise, media noise, etc. Early 78 rpm phonograph discs had a dynamic range of up to 40 dB, [24] soon reduced to 30 dB and worse due to wear from repeated play. Vinyl microgroove phonograph ...
SNR is usually taken to indicate an average signal-to-noise ratio, as it is possible that instantaneous signal-to-noise ratios will be considerably different. The concept can be understood as normalizing the noise level to 1 (0 dB) and measuring how far the signal 'stands out'.
The commonly used reference sound exposure in air is [2] = . The proper notations for sound exposure level using this reference are L W/(400 μPa 2 ⋅s) or L W (re 400 μPa 2 ⋅s), but the notations dB SEL, dB(SEL), dBSEL, or dB SEL are very common, even if they are not accepted by the SI.
dBc (decibels relative to the carrier) is the power ratio of a signal to a carrier signal, expressed in decibels.For example, phase noise is expressed in dBc/Hz at a given frequency offset from the carrier. dBc can also be used as a measurement of Spurious-Free Dynamic Range between the desired signal and unwanted spurious outputs resulting from the use of signal converters such as a digital ...