enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Width across flats - Wikipedia

   en.wikipedia.org/wiki/Width_across_flats

   A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

3. Socket wrench - Wikipedia

   en.wikipedia.org/wiki/Socket_wrench

   A socket wrench (or socket spanner) is a type of spanner (or wrench [1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt. [2] The most prevalent form is the ratcheting socket wrench, often informally called a ratchet.

4. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Standard 12-point hex socket bits and wrenches fit these screws. The screw heads are typically flanged, and may fit into standard Allen hex socket cap screw counterbores molded or machined into parts to be fastened. Compared to Allen hex sockets, the advantages of these bolts include higher torque capability and the lack of a recess to trap water.

5. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   British Standard Whitworth (BSW) is an imperial-unit-based screw thread standard, devised and specified by Joseph Whitworth in 1841 and later adopted as a British Standard. It was the world's first national screw thread standard, and is the basis for many other standards, such as BSF , BSP , BSCon , and BSCopper .

6. These Standardized Socket Sets Make Short Work of Auto and ...

   www.aol.com/lifestyle/standardized-socket-sets...

   For premium support please call: 800-290-4726 more ways to reach us

7. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 10 mm for a M10×1.5 tap), and pitch is the pitch of the thread (1.5 mm in the case of a standard M10 tap) and so the correct drill size is 8.5 mm. This works for both fine and coarse pitches, and also produces an approximate 75% thread.