Search results
Results from the WOW.Com Content Network
A graphic representation of a daisy chain A daisy garland, a chain of daisy flowers A series of devices connected in a daisy chain layout. In electrical and electronic engineering, a daisy chain is a wiring scheme in which multiple devices are wired together in sequence or in a ring, [1] similar to a garland of daisy flowers. Daisy chains may ...
The daisy chain cable configuration means that a message walks the chain until it reaches the target device identified in the data packet. Responses then walk the rest of the way down the chain and back up again to reach the system. Some packets may be broadcast to all devices. A command data packet consists: Address byte (1) message header
A fieldbus is an industrial network system for real-time distributed control. It is a way to connect instruments in a manufacturing plant. A fieldbus works on a network structure which typically allows daisy-chain, star, ring, branch, and tree network topologies.
The basic logical address space is 32K words, but the high 4K of physical address space (addresses 160000 8 through 177777 8 in the absence of memory management) are not populated because input/output registers on the bus respond to addresses in that range. So originally, a fully expanded PDP-11 had 28K words, or 56 kbytes in modern terms.
Most are built from simple two-port networks called "sections". There is no formal definition of a section except that it must have at least one series component and one shunt component. Sections are invariably connected in a "cascade" or "daisy-chain" topology, consisting of additional copies of the same section or of completely different ...
The specification requires a 'terminator' to be connected to the final OUT or THRU connector of the last slave on the daisy chain, which would otherwise be unconnected. A terminator is a stand-alone male connector with an integral 120 Ω resistor connected across the primary data signal pair; this resistor matches the cable's characteristic ...
Daisy-chaining is a feature that must be specifically supported by each intermediary display; not all DisplayPort 1.2 devices support it. Daisy-chaining requires a dedicated DisplayPort output port on the display. Standard DisplayPort input ports found on most displays cannot be used as a daisy-chain output. Only the last display in the daisy ...
Note: the daisy-chain configuration doesn't need more than one shared CS; Typically lower power requirements than I²C or SMBus due to less circuitry (including pull up resistors) Single main means no bus arbitration (and associated failure modes) - unlike CAN-bus; Transceivers are not needed - unlike CAN-bus