Search results
Results from the WOW.Com Content Network
The converting process occurs in a converter. Two kinds of converters are widely used: horizontal and vertical. Horizontal converters of the Peirce-Smith type (which are an improvement of the Manhès-David converter ) prevail in the metallurgy of non-ferrous metals. Such a converter is a horizontal barrel lined with refractory material inside.
Metal plates could be stored and reused, which made this method an attractive option for music engravers. Copper was the initial metal of choice for early plates, but by the eighteenth century pewter became the standard material due to its malleability and lower cost. [2] At first, plates were engraved freely by hand.
Molten metal before casting Casting iron in a sand mold. In metalworking and jewelry making, casting is a process in which a liquid metal is delivered into a mold (usually by a crucible) that contains a negative impression (i.e., a three-dimensional negative image) of the intended shape.
Armoured steel must be hard, yet resistant to shock, in order to resist high velocity metal projectiles. Steel with these characteristics is produced by processing cast steel billets of appropriate size and then rolling them into plates of required thickness. Hot rolling homogenizes the grain structure of the steel, changing the crystalline ...
Protective metal plates that became available when cast iron was developed enabled fires to be placed against walls without danger to the fabric of the building. The other function of the fireback is to act as a radiator of stored heat. The metal is heated by the fire, and then that heat is radiated into the room.
Metal stands and holders are used to support percussion instruments or microphones. Floor stands are often tripods and telescoping. Tom-tom and cymbal stands may have a "boom arm" attached to extend holder reach, and a "tilter" to move instruments into a desired position. Smaller "clamp holders" may also be used to attach more instruments to ...
Improvised armour added to a truck by railway shop workers for the Danish resistance movement near the end of World War II. Improvised vehicle armour is a form of vehicle armour consisting of protective materials added to a vehicle such as a car, truck, or tank in an irregular and extemporized fashion using available materials.
The pig iron was melted in this and run out into a trough. The slag separated, and floated on the molten iron, and was removed by lowering a dam at the end of the trough. The effect of this process was to desiliconise the metal, leaving a white brittle metal, known as 'finers metal'. This was the ideal material to charge to the puddling furnace.