Search results
Results from the WOW.Com Content Network
An elbow is installed between two lengths of pipe (or tubing) to allow a change of direction, usually a 90° or 45° angle; 22.5° elbows are also available. The ends may be machined for butt welding, threaded (usually female), or socketed. When the ends differ in size, it is known as a reducing (or reducer) elbow.
Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.
In 1921 the Building Code Committee and in 1925 a report was issued titled "Recommended Practice for Arrangement of Building Codes" which consisted of 19 chapters, including Chapter 15 on plumbing. This report was known informally as the "Hoover Code" as it was issued under the signature of the Secretary of Commerce Herbert Hoover.
Plastic Pipe lengths manufactured in Australia by extruding HDPE material.. Plastic pipe is a tubular section, or hollow cylinder, made of plastic.It is usually, but not necessarily, of circular cross-section, used mainly to convey substances which can flow—liquids and gases (fluids), slurries, powders and masses of small solids.
STATE OF COLORADO Department of State 1700 Broadway Suite 200 Denver, CO 80290 Scott Gessler Secretary of State William A. Hobbs Deputy Secretary of State Main Number Administrati
But Trump's call to suspend limits on borrowing -- at a time the federal government's debt exceeds $36 trillion -- runs against long-voiced Republican concerns about fiscal profligacy in Washington.
Days before he retires as chairman of the influential U.S. Senate Foreign Relations Committee, Democrat Ben Cardin acknowledged worries about human rights being less of a U.S. priority during ...
PVC conduit has long been considered the lightest in weight compared to steel conduit materials, and usually lower in cost than other forms of conduit. [3] In North American electrical practice, it is available in thirteen different size and wall thicknesses, [ 4 ] with the thin-wall variety only suitable for embedded use in concrete, and ...