enow.com Web Search

  1. Ads

    related to: water well pump check valve problems

Search results

  1. Results from the WOW.Com Content Network
  2. Water hammer - Wikipedia

    en.wikipedia.org/wiki/Water_hammer

    To keep water hammer low, pipe-sizing charts for some applications recommend flow velocity at or below 1.5 m/s (4.9 ft/s). Fit slowly closing valves. Toilet fill valves are available in a quiet fill type that closes quietly. Non-slam check valves do not rely on fluid flow to close and will do so before the water flow reaches significant velocity.

  3. Pumpjack - Wikipedia

    en.wikipedia.org/wiki/Pumpjack

    4 Water well pumpjacks. 5 ... 10 horsepower or 7.5 kilowatts can cause powerline problems, ... tubing is the down-hole pump. This pump has two ball check valves: ...

  4. Reduced pressure zone device - Wikipedia

    en.wikipedia.org/wiki/Reduced_pressure_zone_device

    Because certain combinations of check valve failure and/or system backpressure cause the relief valve to discharge, the device must be mounted in a location where the drain will not become flooded. An example of where backflow would harm the water supply is the use of well washing devices inside underground sewerage pumping stations.

  5. Hydraulic ram - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_ram

    The momentum of the water flow in the inlet pipe against the now closed waste valve causes a water hammer that raises the pressure in the pump beyond the pressure caused by the water column pressing down from the outlet. This pressure differential now opens the delivery valve [5], and forces some water to flow into the delivery pipe [3].

  6. Check valve - Wikipedia

    en.wikipedia.org/wiki/Check_valve

    A check valve, non-return valve, reflux valve, retention valve, foot valve, or one-way valve is a valve that normally allows fluid (liquid or gas) to flow through it in only one direction. [1] Check valves are two-port valves, meaning they have two openings in the body, one for fluid to enter and the other for fluid to leave. There are various ...

  7. Injector - Wikipedia

    en.wikipedia.org/wiki/Injector

    The S type pump is useful for removing water from a well or container. Shallow well pumps are those in which the jet assembly is attached directly to the main pump and are limited to a depth of approximately 5-8m to prevent cavitation. Deep well pumps are those in which the jet is located at the bottom of the well. The maximum depth for deep ...

  1. Ads

    related to: water well pump check valve problems