Search results
Results from the WOW.Com Content Network
IPC is a trade association whose aim is to standardize the assembly and production requirements of electronic equipment and assemblies. IPC is headquartered in Bannockburn, Illinois, United States with additional offices in Washington, D.C. Atlanta, Ga., and Miami, Fla. in the United States, and overseas offices in China, Japan, Thailand, India, Germany, and Belgium.
According to IPC's standard J-STD-012, Implementation of Flip Chip and Chip Scale Technology, in order to qualify as chip scale, the package must have an area no greater than 1.2 times that of the die and it must be a single-die, direct surface mountable package.
Populated (rear) and unpopulated (front) TSOP land patterns on a printed circuit board. A row of through-holes acting as the footprint for a pin header.. A footprint or land pattern is the arrangement of pads (in surface-mount technology) [1] or through-holes (in through-hole technology) used to physically attach and electrically connect a component to a printed circuit board.
The IPC-NC-349 format is the only IPC standard governing drill and routing formats. [5] XNC is a strict subset of IPC-NC-349, Excellon a big superset. Many indefinite NC files pick some elements of the IPC standard. [1] A digital rights managed copy of the specification is available from the IPC website, for a fee.
IPC standards revised the definition of a microvia in 2013 to a hole with depth to diameter aspect ratio of 1:1 or less, and the hole depth not to exceed 0.25mm. Previously, microvia was any hole less than or equal to 0.15mm in diameter [ 2 ]
Eurocard is an IEEE standard format for printed circuit board (PCB) cards that can be plugged together into a standard chassis which, in turn, can be mounted in a 19-inch rack. The chassis consists of a series of slotted card guides on the top and bottom, into which the cards are slid so they stand on end, like books on a shelf.
To produce a quality solder joint, it's very important for the spheres of metal to be very regular in size and have a low level of oxidation [citation needed]. Solder pastes are classified based on the particle size by IPC standard J-STD 005. [3] The table below shows the classification type of a paste compared with the mesh size and particle ...
The most common [citation needed] standards for conformal coating are IPC A-610 [9] and IPC-CC-830. [10] These standards list indications of good and bad coverage and describe various failure mechanisms, such as dewetting. Another type of coating called parylene is applied with a vacuum deposition process at ambient temperature. Film coatings ...