enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Table saw - Wikipedia

   en.wikipedia.org/wiki/Table_saw

   Miter gauge: The table has one or two slots (grooves) running from front to back, also parallel to the cutting plane of the blade. These miter slots (or miter grooves) are used to position and guide either a miter gauge (also known as a crosscut fence) or crosscut sled. The miter gauge is usually set to be at 90 degrees to the plane of the ...

3. Miter gauge - Wikipedia

   en.wikipedia.org/wiki/Miter_gauge

   A miter gauge is a device used for holding workpieces at a set angle while being cut on table saws, band saws or sanded on stationary disk sanders. The miter gauge slides in a slot on the worktable (known as a miter slot) on the machine being used. Typically, the miter gauge and the workpiece are held together by hand and moved across the ...

4. Miter square - Wikipedia

   en.wikipedia.org/wiki/Miter_square

   A miter square or mitre square is a hand tool used in woodworking and metalworking for marking and checking angles other than 90°. Most miter squares are for marking and checking 45° angles and its supplementary angle, 135°. [1][2] A miter is a bevelled edge – usually 45° – used, for example, for making miter joints for woodworking. [2]

5. Miter saw - Wikipedia

   en.wikipedia.org/wiki/Miter_saw

   A motorized miter saw. A miter saw or mitre saw is a saw used to make accurate crosscuts and miters in a workpiece by positioning a mounted blade onto a board. A miter saw in its earliest form was composed of a back saw in a miter box, but in modern implementation consists of a powered circular saw that can be positioned at a variety of angles and lowered onto a board positioned against a ...

6. Square (tool) - Wikipedia

   en.wikipedia.org/wiki/Square_(tool)

   Pens, pencils, scribes, drawing boards, and plum bobs. A square is a tool used for marking and referencing a 90° angle, though mitre squares are used for 45° angles. Squares see common use in woodworking, metalworking, construction and technical drawing. [1] Some squares incorporate a scale for measuring distances (a ruler) or for calculating ...

7. Miter clamp - Wikipedia

   en.wikipedia.org/wiki/Miter_clamp

   The earliest mitre clamps are a simple spring in a C-shape with sharpened points that are sprung onto the outside corner of the mitre joint. [citation needed] In a later design, right angled plates are higher than the screws and the holder. [citation needed] The screws go under the frame (work-piece) to be held, and the bit clamps down on the ...