Search results
Results from the WOW.Com Content Network
When I. Mechanic's Assistant chat. Customer: 2006 Jetta 2.0 FSI using the vagcom I have code 01314 engine control module check DTC memory in my abs module. When I scan the engine control module I have code p1545 which is for the throttle valve controller and I have code p2293 which is for the fuel pressure regulator valve.
I have found the location of the chassis ecu’s (332/x8917) but I think there should be another ecu for the engine. The 320/09705 is specified by JCB as the ecu for the tier 4 engine. 17+ yrs. shop and field experience with all major brands of heavy equipment and trucks - 1995 WyoTech graduate.
1. At key on, engine off, disconnect the Mass Air Flow (MAF) Sensor. 2. Check the voltage on the Yellow wire at pin 1 of the MAF connector. 3. If the voltage is greater than 5.0 volts, verify a good ground on pins 2, 4 and 6 of the X2 connector at the ECM. 4. If the ground is good, replace the ECM.
The fuel injection control module (FICM) self monitors driver performance and sends this information to the engine control module (ECM) through the CAN system. If a fault is detected in the driver circuits, the FICM will signal the ECM, and DTC P1658 will set. This is an internal circuit fault, and can not be caused by external failures.
The U1345 DTC code stands for "Engine Control Module LIN Bus 1". The Local Interconnect Network (LIN) Bus consists of a single wire with a transmission rate of 10.417 Kbit/s. The serial data is transmitted over a LIN circuit between a master control module and other LIN devices within a particular subsystem. If serial data communication is lost ...
This code is for low voltage at the engine control module. there is NOT an automatic fix for this. Possible causes are the relay to the engine control module, short in wiring harness or a faulty engine control module. You have to do testing to determine which is faulty. Copy and past the links below to open the testing file and diagram file
JACUSTOMER-di6gidyg- : According to another site, the ignition control module is located on the left fender skirt. It is no there. This engine has the push on rotor. Bob : Some have the ignition module on the distributor similar to this. Full Size Image. Bob :
Customer: The powertrain control module (PCM) or engine control module (ECM will automatically clear a diagnostic trouble code (DTC) if there are no additional faults detected afterA. Eighty warm-up-cycle. C. The criteria to clear codes is reached.
The sensor on the back of the engine that goes through the bell housing of the trans is the crank sensor not the cam sensor. The crank sensor is near the other two modules, so make sure to go over the wires looking for shorts. The instrument cluster is a duel purpose cluster. the instrument cluster is the bcm.
Where is the engine control module located on a 2015 Nissan Versa Note. 130,000. Doing it myself, just broke down this