Ads
related to: grade 1 vs 2 lumberhomedepot.com has been visited by 1M+ users in the past month
advantagelumber.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Lumber is then grouped based on the grade. To create lengths of glulam longer than those typically available for sawn lumber, the lumber must be end-jointed. The most common joint for this is a finger joint , 1.1 in (2.8 cm) in length that is cut on either end with special cutter heads.
Based on the American West Coast Lumber Inspection Bureau (WCLIB) grading rules, [6] there is only one grade of stud: STUD. A stud is graded for vertical application and its stress requirements and allowable visual defects reflect that application. A stud is most similar to a #2 grade, which is held to a higher standard during grading.
In 1961, at a meeting in Scottsdale, Arizona, the Committee on Grade Simplification and Standardization agreed to what is now the current U.S. standard: in part, the dressed size of a 1-inch (nominal) board was fixed at 3 ⁄ 4 inch; while the dressed size of 2 inch (nominal) lumber was reduced from 1 + 5 ⁄ 8 inch to the current 1 + 1 ⁄ 2 inch.
Five grades of OSB are defined in EN 300 in terms of their mechanical performance and relative resistance to moisture: [2] OSB/0 – No added formaldehyde; OSB/1 – General-purpose boards and boards for interior fitments (including furniture) for use in dry conditions; OSB/2 – Load-bearing boards for use in dry conditions
In 1971 "Micro=Lam LVL" was introduced. "Micro=Lam LVL" consisted of laminated veneer lumber billets 4 feet (1.2 m) wide, 3 + 1 ⁄ 2 inches (89 mm) thick, and 80 feet (24 m) long. Troutner proved the structural capabilities of his Micro=Lam product by building a house in Hagerman, Idaho, using beams made of Micro=Lam.
The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2, 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm). Typically the beams are made to a ...
Ads
related to: grade 1 vs 2 lumberhomedepot.com has been visited by 1M+ users in the past month
advantagelumber.com has been visited by 10K+ users in the past month