Search results
Results from the WOW.Com Content Network
Baseboard, "base moulding" or "skirting board": Used to conceal the junction of an interior wall and floor, to protect the wall from impacts and to add decorative features. A "speed base" makes use of a base "cap moulding" set on top of a plain 1" thick board, however there are hundreds of baseboard profiles.
Installing baseboards is an achievable DIY with the right know-how to ensure you get a professional finish, whether you're updating a living room or refining a home addition.
Pages in category "Chart patterns" The following 11 pages are in this category, out of 11 total. This list may not reflect recent changes. B. Broadening top; C.
At its simplest, baseboard consists of a simple plank nailed, screwed or glued to the wall; however, particularly in older houses, it can be made up of a number of moldings for decoration. A baseboard differs from a wainscot ; a wainscot typically covers from the floor to around 1-1.5 metres (3' to 5') high (waist or chest height), whereas a ...
90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.
A coped joint A scribed joint (right end of sketch) is derived from an internal mitre cut (left end) by cutting along the inside face of the mitre cut at a right angle to the board, typically with a coping saw.
A miter square or mitre square is a hand tool used in woodworking and metalworking for marking and checking angles other than 90°. Most miter squares are for marking and checking 45° angles and its supplementary angle, 135°. [1] [2] A miter is a bevelled edge – usually 45° – used, for example, for making miter joints for woodworking. [2]
There are several types of butt joint based on the orientation of the pieces being joined. These include the T-butt, end-to-end butt, Miter butt and edge-to-edge butt. The T-butt joint is a very simple joint to construct. Members are simply docked (cut off) at a right angle and at the required length.