Search results
Results from the WOW.Com Content Network
All light fixtures have a fixture body and one or more lamps. The lamps may be in sockets for easy replacement—or, in the case of some LED fixtures, hard-wired in place. Fixtures may also have a switch to control the light, either attached to the lamp body or attached to the power cable.
They enable computer control via networked switches, but do not require it. Their cost is about the same as the older "dimmability" circuitry that they replace in LED bulbs, fixtures or drivers. A residential-type dimmer switch with sliding knob to change brightness. The device is small enough to fit into a regular wall box provided for a switch.
Wedge base lamps are widely used in automotive applications, and many Christmas lights strings use plastic wedge-based bulbs. Other wedge bases include strip lamps, sometimes called architectural lamps, with S14s connections. These lamps are used in display cabinets or over mirrors and have been widely replaced by LED equivalents.
Two light switches in one box. The switch on the right is a dimmer switch. The switch box is covered by a decorative plate. The first light switch employing "quick-break technology" was invented by John Henry Holmes in 1884 in the Shieldfield district of Newcastle upon Tyne. [1]
Because of the presence of a neutral fuse, and in the event that it blew, the neutral conductor could not be relied on to remain near ground potential; and, in fact, could be at full line potential (via transmission of voltage through a switched-on light bulb, for example). [5] Modern electrical codes generally do not require a neutral fuse.
In building wiring, multiway switching is the interconnection of two or more electrical switches to control an electrical load from more than one location.A common application is in lighting, where it allows the control of lamps from multiple locations, for example in a hallway, stairwell, or large room.
A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...
The dimmer switch used in conjunction with a dimmable CFL must be matched to its power consumption range; [58] many dimmers installed for use with incandescent bulbs do not function acceptably below 40 W, whereas CFL applications commonly draw power in the range 7–20 W. Dimmable CFLs have been marketed before suitable dimmers are available.