Search results
Results from the WOW.Com Content Network
A syringe is a simple reciprocating pump consisting of a plunger (though in modern syringes, it is actually a piston) that fits tightly within a cylindrical tube called a barrel. The plunger can be linearly pulled and pushed along the inside of the tube, allowing the syringe to take in and expel liquid or gas through a discharge orifice at the ...
This spring and the associated mechanical components form a one-shot linear actuator. [citation needed] When triggered the actuator drives a three-step sequence: [citation needed] accelerate the syringe forward, puncturing the injection site; actuate the piston of the syringe, injecting the drug; deploy a shield to cover the needle
A hypodermic syringe has the ability to retain liquid and blood in it up to years after the last use and a great deal of caution should be taken to use a new syringe every time. The hypodermic needle also serves an important role in research environments where sterile conditions are required.
Injector pens remove some of the complications of syringes by allowing the pen to be "pushed" against the skin at a 90-degree angle (removing the need to inject at a proper angle as is the case with syringes), as well as by replacing a long, thin plunger of a syringe with a simple button which is depressed and held to inject the dose.
A syrette is a single-use device for injecting liquid through a needle. It is similar to a syringe except that it has a sealed squeeze tube instead of a rigid tube and piston.
The insulin syringe was the first syringe that is considered low dead space. It was initially created with low dead space for accurate measuring and mixing of fast and slow acting insulin, which had the added benefit of wasting as little of the expensive drug as possible.
Safety needles [1] serve the same functions as safety syringes, but the protective mechanism is a part of the needle rather than the syringe. Legislation requiring safety syringes or equivalents has been introduced in many nations since needlestick injuries and re-use prevention became the focus of governments and safety bodies.
Like a ground glass stopcock, the two parts of a gas syringe should preferably not be interchanged with another gas syringe of the same volume, unless told otherwise by the distributor. [3] Gas syringes come in various sizes from 500 ml to 0.25 ml and tend to be accurate to between 0.01 and 1 ml, depending on the size of the syringe. [4]