Search results
Results from the WOW.Com Content Network
The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada. [1] It equals the volume of a board that is one foot (30.5 cm) in length, one foot in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters. Board foot can be abbreviated as FBM (for "foot, board measure"), BDFT ...
A cord is the amount of wood that, when "racked and well stowed" (arranged so pieces are aligned, parallel, touching, and compact), occupies a volume of 128 cubic feet (3.62 m 3). [1] This corresponds to a well-stacked woodpile 4 feet (122 cm) high, 8 feet (244 cm) wide, and 4 feet (122 cm) deep; or any other arrangement of linear measurements ...
The centimetre (SI symbol: cm) is a unit of length in the metric system equal to 10 −2 metres ( 1 / 100 m = 0.01 m). To help compare different orders of magnitude , this section lists lengths between 10 −2 m and 10 −1 m (1 cm and 1 dm).
Length; system unit code (other) symbol or abbrev. notes conversion factor/m combinations SI: gigametre: Gm Gm US spelling: gigameter 1.0 Gm (620,000 mi) megametre: Mm Mm US spelling: megameter
Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article. Exceptions are made if the unit is commonly known by another name (for example, 1 micron = 10 −6 metre).
As previously noted, less wood is needed to produce a given finished size than when standards called for the green lumber to be the full nominal dimension. However, even the dimensions for finished lumber of a given nominal size have changed over time. In 1910, a typical finished 1-inch (25 mm) board was 13 ⁄ 16 in (21 mm). In 1928, that was ...
For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200 ⁄ 3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0.9144 ...
The length and diameter measurements of the limbs can be accomplished by climbers physically measuring these values, or through remote methods, or a combination of both. In most cases the branch diameters are only measured down to a certain lower size limit, and the volume of the remaining finer branches is ignored, or extrapolated. [citation ...