Search results
Results from the WOW.Com Content Network
In some occasional cases, a sink may have both a potable (drinkable) and a non-potable water supply. Lavatories and water closets normally connect to the water supply by means of a supply , which is a tube, usually of nominal 3/8 in ( United States ) or 10 or 12 mm diameter ( Europe and Middle East ), which connects the water supply to the ...
Stainless steel is most commonly used in kitchens and commercial applications because it represents a good trade-off between cost, usability, durability, and ease of cleaning. [2] Most stainless steel sinks are made by drawing a sheet of stainless steel over a die. Some very deep sinks are fabricated by welding. Stainless steel sinks will not ...
A glass stopper is often called a "ground glass joint" (or "joint taper"), and a cork stopper is called simply a "cork". Stoppers used for wine bottles are referred to as "corks", even when made from another material. [citation needed] A common every-day example of a stopper is the cork of a wine bottle.
For premium support please call: 800-290-4726 more ways to reach us
Stainless steel, also known as inox, corrosion-resistant steel (CRES), or rustless steel, is an iron-based alloy containing a minimum level of chromium that is resistant to rusting and corrosion. Stainless steel's resistance to corrosion results from the 10.5% or more chromium content, which forms a passive film that can protect the material ...
Isometric projection of a grub screw with a hex socket head.. Set screws are not always the best way to resist the torque of driven shafts. To reduce the chance of slipping and to increase load capacity, a detent (often called a "flat") may be milled or ground at the part of the shaft where the set screw's point contacts.
One component is a rod that is inserted into the existing hole in the workpieces; the other component is the cutter, which is attached to the rod, or extends out of it, after it is in position. [3] This is comparable to other types of "back-" machining, such as back-spotfacing, back-boring, back-counterboring, back-milling, and back-deburring.
[2] Since flow rates are low and many turns of the valve stem are required to completely open or close, needle valves are not used for simple shutoff applications. Since the orifice is small and the force advantage of the fine-threaded stem is high, needle valves are usually easy to shut off completely, with merely "finger-tight" pressure.