enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Polyvinyl chloride - Wikipedia

   en.wikipedia.org/wiki/Polyvinyl_chloride

   Polyvinyl chloride is formed in flat sheets in a variety of thicknesses and colors. As flat sheets, PVC is often expanded to create voids in the interior of the material, providing additional thickness without additional weight and minimal extra cost (see closed-cell PVC foamboard). Sheets are cut using saws and rotary cutting equipment.

3. Vinyl composition tile - Wikipedia

   en.wikipedia.org/wiki/Vinyl_composition_tile

   Vinyl floor tiling. Vinyl composition tile (VCT) is a finished flooring material used primarily in commercial and institutional applications. Modern vinyl floor tiles and sheet flooring and versions of those products sold since the early 1980s are composed of colored polyvinyl chloride (PVC) chips formed into solid sheets of varying thicknesses (1 ⁄ 8 in or 3.2 mm is most common) by heat and ...

4. Closed-cell PVC foamboard - Wikipedia

   en.wikipedia.org/wiki/Closed-cell_PVC_foamboard

   PVC foamboard is distinct from the extra-lightweight foamcore board, laminated of foam and card surfaces, used for indoor signage and modelling. Like PVC, closed-cell PVC foamboard is solid and has a very rigid structure. Where it differs is in its closed-cell foam structure, which makes it very light (as little as half the weight of solid PVC ...

5. Sheet metal - Wikipedia

   en.wikipedia.org/wiki/Sheet_metal

   Sheet metal is available in flat pieces or coiled strips. The coils are formed by running a continuous sheet of metal through a roll slitter. In most of the world, sheet metal thickness is consistently specified in millimeters. In the U.S., the thickness of sheet metal is commonly specified by a traditional, non-linear measure known as its ...

6. Roll forming - Wikipedia

   en.wikipedia.org/wiki/Roll_forming

   It typically begins with a large coil of sheet metal, between 1 inch (2.5 cm) and 20 inches (51 cm) in width, and 0.004 inches (0.10 mm) and 0.125 inches (3.2 mm) thick, supported on an uncoiler. The strip is fed through an entry guide to properly align the material as it passes through the rolls of the mill, each set of rolls forming a bend ...

7. Sheet Metal and Air Conditioning Contractors' National ...

   en.wikipedia.org/wiki/Sheet_Metal_and_Air...

   The Sheet Metal and Air Conditioning Contractors' National Association (SMACNA; pronounced 'Smack'-'Nah') is an international trade association with more than 4,500 contributing contractor members [1] in 103 chapters [2] throughout the United States, Canada, Australia and Brazil.

8. Category:Metal companies of Singapore - Wikipedia

   en.wikipedia.org/wiki/Category:Metal_companies...

   Pages in category "Metal companies of Singapore" This category contains only the following page. ... This page was last edited on 10 October 2019, at 21:24 (UTC).

9. Polystyrene - Wikipedia

   en.wikipedia.org/wiki/Polystyrene

   Sheets of EPS are commonly packaged as rigid panels (common in Europe is a size of 100 cm x 50 cm, usually depending on an intended type of connection and glue techniques, it is, in fact, 99.5 cm x 49.5 cm or 98 cm x 48 cm; less common is 120 x 60 cm; size 4 by 8 ft (1.2 by 2.4 m) or 2 by 8 ft (0.61 by 2.44 m) in the United States). Common ...