Search results
Results from the WOW.Com Content Network
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections .
The "Drive-cycle" basically is the representative of the road. Drive cycles are used to reduce the expense of on road tests, time of test and fatigue of the test engineer. The whole idea is to bring the road to the test lab (a chassis dynamo-meter) or to the computer simulation. Two kinds of drive cycle can be made.
OBD-II is an improvement over OBD-I in both capability and standardization. The OBD-II standard specifies the type of diagnostic connector and its pinout, the electrical signalling protocols available, and the messaging format. It also provides a candidate list of vehicle parameters to monitor along with how to encode the data for each.
Condition 2: The same engine at sea level will achieve that same 50 kPa (7.25 psi, 14.7 inHG) of manifold pressure at less than (before reaching) WOT due to the higher barometric pressure. The engine requires the same mass of fuel in both conditions because the mass of air entering the cylinders is the same.
The Worldwide Harmonised Light vehicles Test Procedure (WLTP) [1] is a global driving cycle standard for determining the levels of pollutants, CO 2 emission standards and fuel consumption of conventional internal combustion engine (ICE) and hybrid automobiles, as well as the all-electric range of plug-in electric vehicles.
For example, the vehicle computer can identify past driving history as one particular representative cycle (say, FTP-75) and use known information from FTP-75 to improve vehicle performance. This type of control strategy is most useful for hybrid vehicles where the control strategy has a much greater effect on vehicle performance than with a ...
Unified Diagnostic Services (UDS) is a diagnostic communication protocol used in electronic control units (ECUs) within automotive electronics, which is specified in the ISO 14229-1. [1] It is derived from ISO 14230-3 and the now obsolete ISO 15765-3 (Diagnostic Communication over Controller Area Network (DoCAN) [2]). 'Unified' in this context ...
This page was last edited on 4 January 2008, at 08:58 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may ...