Search results
Results from the WOW.Com Content Network
In Chicago, a typical city block is 330 by 660 feet (100 m × 200 m), [2] meaning that 16 east-west blocks or 8 north-south blocks measure one mile, which has been adopted by other US cities. In much of the United States and Canada, the addresses follow a block and lot number system , in which each block of a street is allotted 100 building ...
It varied in size at various times and places; the Spanish unit was set at about 835.905 mm (32.91 in) in 1801. [citation needed] In Argentina, the vara measured about 866 mm (34.1 in), and typical urban lots are 8.66 m (28.41 ft) wide (10 Argentine varas). At some time a value of 33 inches (838.2 mm) was adopted in California.
Simultaneously, block lengths increase from 200 × 200 feet to 1240 × 200 feet. When all five blocks have reached the ultimate size of 1,240 feet (380 m) four street lengths out of total eight have been eliminated.
Floor area ratio (FAR) is the ratio of a building's total floor area (gross floor area) to the size of the piece of land upon which it is built. It is often used as one of the regulations in city planning along with the building-to-land ratio. [ 1 ]
The Commissioners' Plan did not in any way specify what the size of individual lots within the blocks should be, although the size and rectangular nature of the blocks lent itself to rectangular lots of equal size to fit into the block. A standard lot was 100 feet (30 m) deep, which was half the depth of the block, and 20 or 25 feet (6.1 or 7.6 ...
A Form-Based Code (FBC) is a means of regulating land development to achieve a specific urban form. Form-Based Codes foster predictable built results and a high-quality public realm by using physical form (rather than separation of uses) as the organizing principle, with less focus on land use , through municipal regulations.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Conversion of the Mach unit of speed depends on the altitude at which the speed is measured. That altitude should be specified either in feet (for example, |altitude_ft=10,000) or in metres (for example, |altitude_m=3,749). The altitude cannot be determined accurately and only a whole number is accepted. Examples: