Ad
related to: mechanical stop potentiometer code
Search results
Results from the WOW.Com Content Network
A potentiometer is a three- terminal resistor with a sliding or rotating contact that forms an adjustable voltage divider. [1] If only two terminals are used, one end and the wiper, it acts as a variable resistor or rheostat. The measuring instrument called a potentiometer is essentially a voltage divider used for measuring electric potential ...
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used. For example, an extra "closed throttle position ...
Rotary encoder. A Gray code absolute rotary encoder with 13 tracks. At the top, the housing, interrupter disk, and light source can be seen; at the bottom the sensing element and support components. A rotary encoder, also called a shaft encoder, is an electro-mechanical device that converts the angular position or motion of a shaft or axle to ...
Electronic throttle control (ETC) is an automobile technology that uses electronics to replace the traditional mechanical linkages between the driver's input such as a foot pedal to the vehicle's throttle mechanism which regulates speed or acceleration. This concept is often called drive by wire, [1][2] and sometimes called accelerate-by-wire ...
This may not be the case when a digital potentiometer is used. Both electro-mechanical and digital potentiometers generally have poor tolerances (typically ±20%), [7] poor temperature coefficients [8] (up to many hundreds of ppm per degree C), [8] and a stop resistance that is typically about 0.5-1% of the full scale resistance. Note that stop ...
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with ...
A potentiometer (colloquially, pot) is a three-terminal resistor with a continuously adjustable tapping point controlled by rotation of a shaft or knob or by a linear slider. [23] The name potentiometer comes from its function as an adjustable voltage divider to provide a variable potential at the terminal connected to the tapping point. Volume ...
The sensing electrodes measure the potential difference (the Hall voltage) proportional to the axial component of the magnetic field that is perpendicular to both the current's axis and the sensing electrodes' axis. [5] Hall effect sensors respond to static and changing magnetic fields. Inductive sensors instead only respond to changes in fields.
Ad
related to: mechanical stop potentiometer code