enow.com Web Search

  1. Ads

    related to: difference between cam and crankshaft

Search results

  1. Results from the WOW.Com Content Network
  2. Camshaft - Wikipedia

    en.wikipedia.org/wiki/Camshaft

    A camshaft operating two valves. A camshaft is a shaft that contains a row of pointed cams in order to convert rotational motion to reciprocating motion.Camshafts are used in piston engines (to operate the intake and exhaust valves), [1] [2] mechanically controlled ignition systems and early electric motor speed controllers.

  3. Cam engine - Wikipedia

    en.wikipedia.org/wiki/Cam_engine

    A cam engine is a reciprocating engine where instead of the conventional crankshaft, the pistons deliver their force to a cam that is then caused to rotate. The output work of the engine is driven by this cam. [1] A variation of the cam engine, the swashplate engine (also the closely related wobble-plate engine), was briefly popular. [2]

  4. Cam (mechanism) - Wikipedia

    en.wikipedia.org/wiki/Cam_(mechanism)

    The cam can be seen as a device that converts rotational motion to reciprocating (or sometimes oscillating) motion. [clarification needed] [3] A common example is the camshaft of an automobile, which takes the rotary motion of the engine and converts it into the reciprocating motion necessary to operate the intake and exhaust valves of the cylinders.

  5. Engine configuration - Wikipedia

    en.wikipedia.org/wiki/Engine_configuration

    The crankshaft configuration varies amongst opposed-engine designs. One layout has a flat/boxer engine at its center and adds an additional opposed-piston to each end so there are two pistons per cylinder on each side. An X engine is essentially two V engines joined by a common crankshaft. A majority of these were existing V-12 engines ...

  6. Crankshaft - Wikipedia

    en.wikipedia.org/wiki/Crankshaft

    Crankshaft, pistons and connecting rods for a typical internal combustion engine Marine engine crankshafts from 1942. The crankshaft is located within the engine block and held in place via main bearings which allow the crankshaft to rotate within the block. [3] The up-down motion of each piston is transferred to the crankshaft via connecting ...

  7. Overhead camshaft engine - Wikipedia

    en.wikipedia.org/wiki/Overhead_camshaft_engine

    SOHC design (for a 1973 Triumph Dolomite Sprint) . The oldest configuration of overhead camshaft engine is the single overhead camshaft (SOHC) design. [1] A SOHC engine has one camshaft per bank of cylinders, therefore a straight engine has a total of one camshaft and a V engine or flat engine has a total of two camshafts (one for each cylinder bank).

  8. Radial engine - Wikipedia

    en.wikipedia.org/wiki/Radial_engine

    As with most four-strokes, the crankshaft takes two revolutions to complete the four strokes of each piston (intake, compression, combustion, exhaust). The camshaft ring is geared to spin slower and in the opposite direction to the crankshaft. Its cam lobes are placed in two rows; one for the intake valves and one for the exhaust valves.

  9. Timing belt (camshaft) - Wikipedia

    en.wikipedia.org/wiki/Timing_belt_(camshaft)

    In many older overhead valve engines, the camshaft is located in the block near the crankshaft, therefore a simple gear system is often used to drive the camshaft. Overhead camshaft engines mostly use timing belts or timing chains, since these are better suited to transferring drive over larger distances.

  1. Ads

    related to: difference between cam and crankshaft