enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Lead (tack) - Wikipedia

    en.wikipedia.org/wiki/Lead_(tack)

    The chain end ranges from 18 to 30 inches (46 to 76 cm) long and has a snap or clip on the end that attaches to the halter, and a ring on the other end that is attached to the lead line. [2] Some lead lines are permanently sewn to the chain shank, others have buckles or clips allowing the chain to be removed.

  3. Glossary of equestrian terms - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_equestrian_terms

    [1]: 126 See also lead change. 2. Lead (tack): a lead rope, lead shank or leading rein. A flat line or rope attached to a halter and used to lead the animal when the handler is on the ground. [8]: 295 lead change, change of leg The act of a horse changing from one lead to the other. When performed at a canter or gallop, it is a "flying change

  4. Barrel threads - Wikipedia

    en.wikipedia.org/wiki/Barrel_threads

    The shank length is not always the same at the thread length, which is the case if the insert has a threadless portion (sub-shank) Tenon designates the thread length; Shoulder designates the barrel diameter in front of the thread portion; Unless otherwise mentioned, right hand threads are assumed. Left hand threads are designated "LH".

  5. Chain - Wikipedia

    en.wikipedia.org/wiki/Chain

    Jack chain, a toothed chain used to move logs; Lead shank (or stud chain), used on horses that are misbehaving; Pull switch, an electrical switch operated by a ball chain. Lavatory chain, the chain attached to the cistern of an old-fashioned W.C. in which the flushing power is obtained by a gravity feed from above-head height. Although most ...

  6. Shank - Wikipedia

    en.wikipedia.org/wiki/Shank

    Shank (footwear), part of a shoe or boot; Shank (sewing), a spacing device; Shank (weapon), a makeshift knife or stabbing weapon; Lead shank, a type of lead used for horses; Tang (tools), the back portion of the blade component of a tool; Drill bit shank, the non-cutting end of a drill bit; Sheepshank, a knot used to shorten a rope

  7. Halter - Wikipedia

    en.wikipedia.org/wiki/Halter

    Halters are often plain in design, used as working equipment on a daily basis. In addition to the halter, a lead line, lead shank or lead rope is required to actually lead or tie the animal. It is most often attached to the halter at a point under the jaw, or less often, at the cheek, usually with a snap, but occasionally spliced directly onto ...

  8. The Best New Restaurants in America, 2024 - AOL

    www.aol.com/lifestyle/best-restaurants-america...

    Ease into one of the leather banquettes and glance at your table setting. To the left, across a folded napkin on top of a plate from Utsuwa-no-Yakata in L.A.’s Little Tokyo: a pair of chopsticks ...

  9. Cathead - Wikipedia

    en.wikipedia.org/wiki/Cathead

    An anchor secured to the ship's side. The projecting beam the anchor hangs from when not secured is a cathead (left). The anchor has a stock (cross-piece, in this case wooden) below, and curved flukes above (end-on); the shank is the near-vertical metal bar running between them, lashed with the shank painter Cathead on bow of the barque James Craig; the cat tail protrudes onto the deck and is ...