Ads
related to: reverse brick veneer wall detail diagram imagesbrickit.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
A careful observer will note the wall represented by the elevation is nearly twice the length of the wall shown by the plan diagrams. If the plan diagrams included a greater number of units, the 'L' shapes would appear rather thin; this thinness makes the pattern of units in the plan hard to discern, especially where the image is shrunk to fit ...
In masonry veneer building construction, a shelf angle or masonry support is a steel angle which supports the weight of brick or stone veneer and transfers that weight onto the main structure of the building so that a gap or space can be created beneath to allow building movements to occur.
A wythe may be independent of, or interlocked with, the adjoining wythe(s). A single wythe of brick that is not structural in nature is referred to as a masonry veneer. A standard 8-inch CMU block is exactly equal to three courses of brick. [3] A bond (or bonding) pattern) is the arrangement of several courses of brickwork. [2]
Core-and-veneer, brick and rubble, wall and rubble, ashlar and rubble, and emplekton all refer to a building technique where two parallel walls are constructed and the core between them is filled with rubble or other infill, creating one thick wall. [1] Originally, and in later poorly constructed walls, the rubble was not consolidated.
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
A building's surface detailing, inside and outside, often includes decorative moulding, and these often contain ogee-shaped profiles—consisting (from low to high) of a concave arc flowing into a convex arc, with vertical ends; if the lower curve is convex and higher one concave, this is known as a Roman ogee, although frequently the terms are used interchangeably and for a variety of other ...
In this context, the brick masonry is primarily decorative, not structural. The brick veneer is generally connected to the structural wall by brick ties (metal strips that are attached to the structural wall, as well as the mortar joints of the brick veneer). There is typically an air gap between the brick veneer and the structural wall.
Components on a concrete masonry unit and brick cavity wall. A cavity wall is composed of two masonry walls separated by an air space. The outer wall is made of brick and faces the outside of the building structure. [6] The inner wall may be constructed of masonry units such as concrete block, structural clay, brick or reinforced concrete. [6]
Ads
related to: reverse brick veneer wall detail diagram imagesbrickit.com has been visited by 10K+ users in the past month