Ad
related to: diy how to wire a socket size adapter box for rv refrigerator wiring diagramtemu.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
If you have a trailer with a lot of lights the diode and relay wiring is preferred, but if you have a trailer with a simple light arrangement it is usually sufficient to wire to 58L. In market there are many special converters [ 1 ] [ 2 ] [ 3 ] that solves the problem of connecting a car with European wiring to a trailer with North American wiring.
7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.
Note that the wire cross-section in mm² and AWG listed is the minimum recommended area. For ISO connectors the primary unit is in mm² and AWG has been obtained from a conversion table. For North American connectors the primary unit is AWG and mm² has been obtained from a conversion table. In both cases the figures are rounded up for cable area.
A non-grounded device may be two-pole, two-wire; three-pole, three-wire; etc. [citation needed] The numerals following the hyphen is the current rating of the device in amperes. This number is followed by the letter 'R' to indicate a receptacle (socket) or 'P' to indicate a plug (prongs).
Plug and socket connectors are usually made up of a male plug (typically pin contacts) and a female socket (typically receptacle contacts). Often, but not always, sockets are permanently fixed to a device as in a chassis connector (see above) , and plugs are attached to a cable.
12-volt cigarette lighter receptacle and plug, size A. Receptacle inside diameter: 20.93–21.01 mm (median 20.97 mm) Plug body diameter: 20.73–20.88 mm (median 20.805 mm) Most often used in American automobiles; 12-volt cigarette lighter receptacle and plug, size B. Receptacle inside diameter: 21.41–21.51 mm (median 21.455 mm)
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
Two pin sizes are standard in the jacks for this size plug body, 2.1 mm (0.083 in) and 2.5 mm (0.098 in), and the plugs should match. If the size is not known, it is difficult to distinguish by eye or measurement between the 2.1mm and 2.5mm ID plugs; some suppliers suggest simple methods. [1]
Ad
related to: diy how to wire a socket size adapter box for rv refrigerator wiring diagramtemu.com has been visited by 1M+ users in the past month