Search results
Results from the WOW.Com Content Network
Before you do, “wrap plumber’s tape around the shower arm entrance to create a tight seal and use a wrench to reattach the shower head to the shower arm,” says Peterson. “Use a rag to ...
The first tile cutter was designed to facilitate the work and solve the problems that masons had when cutting a mosaic of encaustic tiles (a type of decorative tile with pigment, highly used in 1950s, due to the high strength needed because of the high hardness and thickness of these tiles).
Blue fiber cement siding HardiePanel on design-build addition, Ithaca NY. Fiber cement siding (also known as "fibre cement cladding" in the United Kingdom, "fibro" in Australia, and by the proprietary name "Hardie Plank" in the United States) is a building material used to cover the exterior of a building in both commercial and domestic applications.
A cement board is a combination of cement and reinforcing fibers formed into sheets, of varying thickness that are typically used as a tile backing board. [1] Cement board can be nailed or screwed to wood or steel studs to create a substrate for vertical tile and attached horizontally to plywood for tile floors, kitchen counters and backsplashes.
Bullnose trim is used to provide a smooth, rounded edge for countertops, staircase steps, building corners, verandas, or other construction.Masonry units such as bricks, concrete masonry units or structural glazed facing tiles may be ordered from manufacturers with square or bullnosed corners.
Weatherproofing seam between a stone chimney and a tile roof on a building in Jersey, Channel Islands. The lead flashing is seen as light gray sheets at the base of the chimney. Flashing is thin pieces of impervious material installed to prevent the passage of water into a structure from a joint or as part of a weather resistant barrier system.
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
The book of Leviticus in the Torah makes mention of corners of the head, and prohibits the marring of the corners of the beard, with particular emphasis on priests (kohanim) not marring the corners of the beard; [4] as with many other parts of Leviticus, the Book of Ezekiel describes different regulations, stating that the priests should not shave their heads, or let their locks grow long.