Search results
Results from the WOW.Com Content Network
A generator interlock kit (or a transfer switch), eliminates the need for extension cords to power appliances. [2]Like a transfer switch, an interlock kit lets the generator energize the panel and all of its circuits (up to the load capacity of the generator); not just corded appliances.
The Brush HMA manufacturing plant is located adjacent to the river, north of Ridderkerk, near Rotterdam in the Netherlands.. The Brush HMA plant at Ridderkerk, not to be confused with the other Holec Ridderkerk enterprise that became part of France's Alstom, has manufactured many different types of electrical machines and associated equipment over the last one hundred twenty years.
Other classifications are considering the windings totally concentrated in one coil per phase or partially concentrated in two poles per phase (i.e., single-sided) or four poles per phase (double-sided). [2] Switched Reluctance motors have been used extensively in clocks and phonograph turntables before, but nowadays, with the rising emphasis ...
In 1897 he invented an electrical configuration to switch between poles in a motor for which he was granted a patent along with his co-worker Karl Arvid Lindström. The new connection was named the "Dahlander connection" and a motor having such a configuration is commonly referred to as a "pole changing motor" or a "Dahlander motor". [4] [5]
An H-bridge is built with four switches (solid-state or mechanical). When the switches S1 and S4 (according to the first figure) are closed (and S2 and S3 are open) a positive voltage is applied across the motor. By opening S1 and S4 switches and closing S2 and S3 switches, this voltage is reversed, allowing reverse operation of the motor.
In micro Pumped-storage hydroelectricity (PSH), the same pump/PAT could be used for pumping and generating phases [8] by changing rotational direction and speed. The best efficiency point in pumping usually differs from its reverse mode: [3] a variable-frequency drive coupled to the motor/generator would be needed in order to change from pumping to generating mode and to react efficiently to ...
[1] [2] The Stirling cycle heat engine can also be driven in reverse, using a mechanical energy input to drive heat transfer in a reversed direction (i.e. a heat pump, or refrigerator). [ 3 ] There are several design configurations for Stirling engines that can be built (many of which require rotary or sliding seals) which can introduce ...
The rotary converter can be thought of as a motor–generator, where the two machines share a single rotating armature and set of field coils. The basic construction of the rotary converter consists of a DC generator (dynamo) with a set of slip rings tapped into its rotor windings at evenly spaced intervals. When a dynamo is spun the electric ...