Ads
related to: power probe pptk0027 digital gauge testerebay.com has been visited by 1M+ users in the past month
products.bestreviews.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Typical passive oscilloscope probe being used to test an integrated circuit. A test probe is a physical device used to connect electronic test equipment to a device under test (DUT). Test probes range from very simple, robust devices to complex probes that are sophisticated, expensive, and fragile. Specific types include test prods ...
Ideal test indicator pushed. Prior to modern geared dial mechanisms, test indicators using a single lever or systems of levers were common. The range and precision of these devices were generally inferior to modern dial type units, with a range of 10/1000 inch to 30/1000 inch, and precision of 1/1000 inch being typical.
The instruments may include device power supplies (DPS), [1] [2] parametric measurement units (PMU), arbitrary waveform generators (AWG), digitizers, digital IOs, and utility supplies. The instruments perform different measurements on the DUT, and the instruments are synchronized so that they source and measure waveforms at the proper times.
Multimeter e.g., VOM (Volt-Ohm-Milliammeter) or DMM (Digital Multimeter) (Measures all of the above) LCR meter - inductance (L), capacitance (C) and resistance (R) meter (measure LCR values) The following are used for stimulus of the circuit under test: Power supplies; Signal generator; Digital pattern generator; Pulse generator
Dial indicator, also known as a dial test indicator, dial gauge, or probe indicator an instrument used to accurately measure small linear distances. Feeler gauge: a simple tool used to measure gap widths. Gauge block, (also known as a gage block, Johansson gauge, slip gauge, or Jo block) a precision ground and lapped length measuring standard.
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.
An autoranging digital multimeter can automatically adjust the scaling network so the measurement circuits use the full precision of the A/D converter. In a digital multimeter the signal under test is converted to a voltage and an amplifier with electronically controlled gain preconditions the signal.
One limitation in flying probe test methods is the speed at which measurements can be taken; the probes must be moved to each new test site on the board, and then a measurement must be completed. Bed-of-nails testers touch each test point simultaneously and electronic switching of instruments between test pins is more rapid than movement of probes.
Ads
related to: power probe pptk0027 digital gauge testerebay.com has been visited by 1M+ users in the past month
products.bestreviews.com has been visited by 1M+ users in the past month