Ads
related to: how match are dimming light switches workebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Since semiconductor or solid-state dimmers switch quickly between a low resistance "on" state and a high resistance "off" state, they dissipate very little power compared with the controlled load. Most recently, software programmable internal dimmers can use signals from the same switch that turns lights on and off to control dimming.
Two light switches in one box. The switch on the right is a dimmer switch. The switch box is covered by a decorative plate. The first light switch employing "quick-break technology" was invented by John Henry Holmes in 1884 in the Shieldfield district of Newcastle upon Tyne. [1]
Dimming fluorescent ballasts and dimming LED drivers often use 0–10 V control signals to control dimming functions. In many cases, the dimming range of the power supply or ballast is limited. If the light output can only be dimmed from 100% down to 10%, there must be a switch or relay available to kill power to the system and turn the light ...
Adjusting the brightness of light emitted by a light source is then merely a matter of setting at what voltage (or phase) in the AC half-cycle the dimmer begins to provide electric current to the light source (e.g. by using an electronic switch such as a triac). In this case the PWM duty cycle is the ratio of the conduction time to the duration ...
Dimmer light switch with RF-based remote control [1] A wireless light switch is a light switch that commands a light or home appliance to turn itself off or on, instead of interrupting the power line going to the light fixture. There are different ways to communicate between the switch and the fixture: [2]
The dimmer switch used in conjunction with a dimmable CFL must be matched to its power consumption range; [58] many dimmers installed for use with incandescent bulbs do not function acceptably below 40 W, whereas CFL applications commonly draw power in the range 7–20 W. Dimmable CFLs have been marketed before suitable dimmers are available.
Digital Serial Interface (DSI) is a protocol for the controlling of lighting in buildings (initially electrical ballasts).It was created in 1991 by Austrian company Tridonic and is based on Manchester-coded 8-bit protocol, data rate of 1200 baud, 1 start bit, 8 data bits (dimming value), 4 stop bits, and is the basis of the more sophisticated protocol Digital Addressable Lighting Interface (DALI).
Compared to a rheostat-based circuit, the use of a thyristor greatly increases efficiency, as far less waste heat is generated. Dimming lights with a solid state dimmer also reduces total power draw, unlike rheostat dimmers. Spira's design (and most modern dimmers) rely on the use of AC power, and on the characteristics of incandescent lights.
Ads
related to: how match are dimming light switches workebay.com has been visited by 1M+ users in the past month