Search results
Results from the WOW.Com Content Network
WinUSB is a generic USB driver provided by Microsoft, for their operating systems starting with Windows Vista but which is also available for Windows XP. It is aimed at simple devices that are accessed by only one application at a time (for example instruments like weather stations, devices that only need a diagnostic connection or for firmware upgrades).
The OHCI driver provides low- and full-speed functions for USB ports of all other motherboard chipset vendors' integrated USB host controllers or discrete host controllers attached to the computer's expansion bus. The EHCI driver provided high-speed functions for USB ports on the motherboard or on the discrete USB controller.
Attempts by the guest operating system to access the hardware are routed to the virtual device driver in the host operating system as e.g., function calls. The virtual device driver can also send simulated processor-level events like interrupts into the virtual machine. Virtual devices may also operate in a non-virtualized environment.
Many device interfaces or protocols (e.g., SATA, USB, SAS, PCIe) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure. Accordingly, this page lists both the internal ribbon and external communications cable standards together in one sortable table.
Typically a device driver, linked to the operating system, controls the host adapter itself. In a typical parallel SCSI subsystem, each device has assigned to it a unique numerical ID. As a rule, the host adapter appears as SCSI ID 7, which gives it the highest priority on the SCSI bus (priority descends as the SCSI ID descends; on a 16-bit or ...
The USB mass storage device class (also known as USB MSC or UMS) is a set of computing communications protocols, specifically a USB Device Class, defined by the USB Implementers Forum that makes a USB device accessible to a host computing device and enables file transfers between the host and the USB device. To a host, the USB device acts as an ...
The signaling rate of the USB device is determined during the reset signaling. After reset, the USB device's information is read by the host and the device is assigned a unique 7-bit address. If the device is supported by the host, the device drivers needed for communicating with the device are loaded and the device is set to a configured state ...
USB 3.0 SuperSpeed – host controller (xHCI) hardware support, no software overhead for out-of-order commands; USB 2.0 High-speed – enables command queuing in USB 2.0 drives; Streams were added to the USB 3.0 SuperSpeed protocol for supporting UAS out-of-order completions USB 3.0 host controller (xHCI) provides hardware support for streams