enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Undercut (turning) - Wikipedia

   en.wikipedia.org/wiki/Undercut_(turning)

   They are often used at the end of the threaded portion of a shaft or screw to provide clearance for the cutting tool, and also referred to as thread relief in this context. A rule of thumb is that the undercut should be at least 1.5 threads long and the diameter should be at least 0.015 in (0.38 mm) smaller than the minor diameter of the thread ...

3. SK Hand Tools - Wikipedia

   en.wikipedia.org/wiki/SK_Hand_Tools

   SK Hand Tools (styled earlier as S-K, now usually SK) is a tool company located in Sycamore, Illinois, with additional manufacturing facilities in China, Taiwan, and Colorado Springs, Colorado. [1] Outlets for their products include independent tool-truck dealers, auto parts stores, and major internet vendors such as Sears and Amazon.com .

4. Blanking and piercing - Wikipedia

   en.wikipedia.org/wiki/Blanking_and_piercing

   The punch/die clearance is a crucial parameter, which determines the load at the cutting edge of the tool, commonly known as point pressure. Excessive point pressure can accelerate tool wear. The surface quality of the trimmed piece is affected by the clearance, too.

5. How to Clean and Remove Stains From a Jetted Tub ... - AOL

   www.aol.com/clean-remove-stains-jetted-tub...

   Remove bath residue once a month by filling the bath with hot water and ¼ cup powdered dishwasher detergent. Run the water jets for 10-15 minutes and then drain the bath and refill with cold water.

6. Springtail - Wikipedia

   en.wikipedia.org/wiki/Springtail

   Springtails (class Collembola) form the largest of the three lineages of modern hexapods that are no longer considered insects.Although the three lineages are sometimes grouped together in a class called Entognatha because they have internal mouthparts, they do not appear to be any more closely related to one another than they are to all insects, which have external mouthparts.

7. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   Taps and dies are tools used to create screw threads, which is called threading. Many are cutting tools; others are forming tools. A tap is used to cut or form the female portion of the mating pair (e.g. a nut). A die is used to cut or form the male portion of the mating pair (e.g. a bolt).

8. Tap wrench - Wikipedia

   en.wikipedia.org/wiki/Tap_wrench

   The clamp is opened to insert the tool and then tightened down against the tool to secure it. This type of tap wrench is used with larger taps and where there is room to turn a larger wrench. [1] A T-handle is more compact. This type of wrench uses a collet to secure the tool. The collet design has two pieces: a threaded "nosecap" and four ...

9. Tang (tools) - Wikipedia

   en.wikipedia.org/wiki/Tang_(tools)

   Rasp with visible tang going into the handle Two sides of a tang (nakago) on a Japanese katana. A tang or shank is the back portion of the blade component of a tool where it extends into stock material or connects to a handle – as on a knife, sword, spear, arrowhead, chisel, file, coulter, pike, scythe, screwdriver, etc. [1] [2] One can classify various tang designs by their appearance, by ...