Ad
related to: working end of a rope system- Custom Splicing
View the Available Splices
And Check Pricing Now.
- Decorative Hardware
We Offer Brackets, End Caps
And Hooks. Buy Online Now.
- Rope Tools
View the Available Rope Tools
And Check Pricing Now.
- Climbing Hardware
We Offer Carabiners, Ascenders,
Arborist Helmets And More Products.
- Custom Splicing
Search results
Results from the WOW.Com Content Network
A bight is a slack part in the middle of a rope, usually a curve or loop. [1] [2] Knots that can be tied without access to either end of the rope are called knots in the bight. To tie a knot with a bight is to double up the rope into a bight and then tie the knot using the double rope.
Knot board [] on Elbe 1 (ship, 1965). A knot is an intentional complication in cordage [1] which may be practical or decorative, or both. Practical knots are classified by function, including hitches, bends, loop knots, and splices: a hitch fastens a rope to another object; a bend fastens two ends of a rope to each another; a loop knot is any knot creating a loop; and splice denotes any multi ...
Half hitch – simple overhand knot, where the working end of a line is brought over and under the standing part; Half-Windsor knot – knot used for tying neckties; Halter hitch – connects a rope to an object; Halyard bend – a way to attach the end of a rope at right angle to a cylindrical object; Hammock hitch
A mnemonic used to teach the tying of the bowline is to imagine the working end of the rope as a rabbit. 1,2 – a loop is made into the standing part which will act as the rabbit's hole; 3 – the "rabbit" comes up the hole, 4 – goes round the tree (standing part) right to left; 5 – and back down the hole
Chain splice – Attached the working end of a rope to a chain. [7] Figure-eight "splice" knot – A splice-like bend knot used for joining two ropes. Horseshoe splice – A cut splice where the two sides of the loop are of unequal length. Long splice – A splice used to join two rope ends forming one rope the length of the total of the two ropes.
However, the rope and knotting expert Geoffrey Budworth warns against the practice of fusing thus: [2] Sealing rope ends this way is lazy and dangerous. A tugboat operator once sliced the palm of his hand open down to the sinews after the hardened (and obviously sharp) end of a rope that had been heat-sealed pulled through his grasp. There is ...
The working end of a rope is prepared by tying a figure-eight loop, and then clipping a carabiner through that loop. The rope is then wrapped around a smooth pole, pipe, round beam or tree branch which has a diameter greater than the rope. The rope is typically wrapped 3 to 4 times around the anchor, without crossing.
The slip knot is a stopper knot which is easily undone by pulling the tail (working end). The slip knot is related to the running knot , which will release when the standing end is pulled. Both knots are identical and are composed of a slipped overhand knot , where a bight allows the knot to be released by pulling on an end; the working end for ...
Ad
related to: working end of a rope system