enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The term fine adjustment screw typically refers to screws with threads from 40–100 TPI (Threads Per Inch) (0.5 mm to 0.2 mm pitch) and ultra fine adjustment screw has been used to refer to 100–254 TPI (0.2 mm to 0.1 mm pitch). These screws are most frequently used in applications where the screw is used to control fine motion of an object.

3. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...

4. Robertson screw - Wikipedia

   en.wikipedia.org/wiki/Robertson_screw

   An earlier patent covering both square-socket- and triangle-socket-drive wood screws, U.S. patent 161,390, was issued to Allan Cummings of New York City on March 30, 1875. As with other drive types conceived and patented in the 1860s through 1890s, it was not manufactured widely during its patent lifespan because of the difficulty and expense ...

5. Fastener - Wikipedia

   en.wikipedia.org/wiki/Fastener

   B18.3 Socket Cap, Shoulder, Set Screws, and Hex Keys (Inch Series) B18.6.1 Wood Screws (Inch Series) B18.6.2 Slotted Head Cap Screws, Square Head Set Screws, And Slotted Headless Set Screws (Inch Series) B18.6.3 Machine Screws, Tapping Screws, and Metallic Drive Screws (Inch Series) B18.18 Quality Assurance For Fasteners

6. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Where a fastener forms its own thread in the component being fastened, it is called a screw. [3] This is most obviously so when the thread is tapered (i.e. traditional wood screws), precluding the use of a nut, [3] or when a sheet metal screw or other thread-forming screw is used. A screw must always be turned to assemble the joint.

7. Nail (fastener) - Wikipedia

   en.wikipedia.org/wiki/Nail_(fastener)

   In woodworking and construction, a nail is a small object made of metal (or wood, called a tree nail or "trunnel") which is used as a fastener, as a peg to hang something, or sometimes as a decoration. [1] Generally, nails have a sharp point on one end and a flattened head on the other, but headless nails are available.