Search results
Results from the WOW.Com Content Network
Long tenons project through the sill plate. Timber sills can span gaps in a foundation. A sill plate or sole plate in construction and architecture is the bottom horizontal member of a wall or building to which vertical members are attached. The word "plate" is typically omitted in America and carpenters speak simply of the "sill".
The terms sole plate or sill plate are used for the members at the bottom of a wall at the foundation but are most often just called a sole or sill without the word plate. Other load-bearing timbers use the term plate but are not in the wall such as crown plate , a purlin -like beam carried by crown posts in roof framing, and a purlin plate ...
They are supported on a bottom plate or foundation sill and in turn support the top plate. Studs usually consist of 1 + 1 ⁄ 2-by-3 + 1 ⁄ 2-inch (38 mm × 89 mm) or 1 + 1 ⁄ 2-by-5 + 1 ⁄ 2-inch (38 mm × 140 mm) lumber and are commonly spaced at 16 inches (410 mm) on center.
sill - a stud sized member forming the base of a window assembly or the base of wall. mudsill - a stud sized member that forms the base of a wall and has been treated against insects and decay. top plate or double top plate - a stud sized member that forms the top of the wall. In cases where other members must bear or brace on the top of the ...
The base plate or floor plate is the bottom attachment point for the wall studs. Using a top plate and a bottom plate, a wall can be constructed while it lies on its side, allowing for end-nailing of the studs between two plates, and then the finished wall can be tipped up vertically into place atop the wall sill; this not only improves ...
This technique eliminated the need for bracing. Some buildings were framed with the posts landing on a foundation with interrupted sills. Most buildings were framed with the posts landing on a heavy timber sill, the sills (rarely) laid on the ground, supported by stones or, late in the 19th century, concrete.
In flooring construction, the rim joists sit on the sill plates; in deck construction, they are parallel to the support beams and sit on the beams or in some cases, cantilever away from the beams. A double thickness board in the position of a rim joist is called a flush beam and serves a dual purpose, providing primary support for the joist ...
It is both a functional and architectural feature that consists of a projection that deflects water running down the face of a building away from lower courses or the foundation. [1] [2] A water table may also be primarily decorative, as found near the base of a wall or at a transition between materials, such as from stone to brick. The top of ...