Search results
Results from the WOW.Com Content Network
The Marmon-Herrington Combat Tank Light Series were a series of American light tanks/tankettes that were produced for the export market at the start of the Second World War. The CTL-3 had a crew of two and was armed with two .30 cal (7.62 mm) M1919 machine guns and one .50 cal (12.7 mm) M2 Browning machine gun .
The Marmon-Herrington Company, Inc. is an American manufacturer of axles and transfer cases for trucks and other vehicles. [1] Earlier, the company built military vehicles and some tanks during World War II, and until the late 1950s or early 1960s was a manufacturer of trucks and trolley buses.
Marmon Class 8 Trucks Model Family Name Production Years Cab Configuration Notes Marmon CHDT: Undefined-1997 Conventional Heavy Duty Tractor: Marmon 54-F: Undefined-1997 Conventional Fleet Shorthood: Marmon 54-P: Undefined-1997 Conventional Premium Shorthood: Marmon 54-FB: Undefined-1997 Conventional Fleet Short Butterfly Hood: Marmon 57-F ...
The new company was called Marmon-Herrington. In the early 1960s, Marmon-Herrington was purchased by the Pritzker family and became a member of an association of companies which eventually adopted the name The Marmon Group. In 2007, the Pritzker family sold a major part of the Group to Warren Buffett's firm Berkshire Hathaway. [10]
A CMTS may also act as a bridge or router. A customer's cable modem cannot communicate directly with other modems on the line. In general, cable modem traffic is routed to other cable modems or to the Internet through a series of CMTSs and traditional routers. However, a route could conceivably pass through a single CMTS.
Current use: no carrier status message shown in widgets of a PC-BSD 10.1.2 network manager (running on MATE).Three network interface widgets (2 Ethernet and 1 WiFi) showing two network interfaces being up, one being down with no cable plugged in (hence: "no carrier"), underlined in red.
If properly configured, the PC can also function as the router for a home LAN. An internal modem can be installed on a single PC (e.g. on a PCI card), also allowing that single PC to connect to a WAN. [7] Again, the PC can be configured to function as a router for a home LAN. A cellular wireless access point can function in a similar fashion to ...
Wireless mesh architecture is a first step towards providing cost effective and low mobility over a specific coverage area. Wireless mesh infrastructure is, in effect, a network of routers minus the cabling between nodes. It is built of peer radio devices that do not have to be cabled to a wired port like traditional WLAN access points (AP) do ...