Search results
Results from the WOW.Com Content Network
The most important method to counter radar jammers is operator training. Any system can be fooled with a jamming signal but a properly trained operator pays attention to the raw video signal and can detect abnormal patterns on the radar screen. The best indicator of jamming effectiveness to the jammer is countermeasures taken by the operator.
When jamming is strong enough, the radar receiver can detect it from a relatively low gain sidelobe. The radar, however, will process signals as if they were received in the main lobe. Therefore, jamming can be seen in directions other than where the jammer is located. To combat this, an omnidirectional antenna is used for a comparison signal ...
Interference techniques include jamming and deception. Jamming is accomplished by a friendly platform transmitting signals on the radar frequency to produce a noise level sufficient to hide echos. [1] The jammer's continuous transmissions will provide a clear direction to the enemy radar, but no range information. [1]
DFR7. This low-cost detector has impressive range and all the requisite features, including GPS for low-speed false-alert muting, manual marking of up to 100 known radar locations, and speed ...
Duke V3 Counter Radio-controlled Electronic Warfare jamming system Duke Version 3 Vehicle mounted CREW system : Duke V3, [ 4 ] manufactured by SRCTec, Inc., is a counter radio-controlled improvised explosive device (RCIED) electronic warfare (CREW) system that was developed to provide U.S. forces critical, life-saving protection against a wide ...
An early radar detector Car radar detector (Japanese) A radar detector is an electronic device used by motorists to detect if their speed is being monitored by police or law enforcement using a radar gun. Most radar detectors are used so the driver can reduce the car's speed before being ticketed for speeding.
To counter this, the jammer has to listen on both frequencies, and broadcast on the one that particular radar is using. To further frustrate these efforts, a radar can rapidly switch between the two frequencies. No matter how quickly the jammer responds, there will be a delay before it can switch and broadcast on the active frequency.
Since a DRFM system is designed to create a false target to a radar system, this technology can be employed to perform hardware-in-the-loop simulation. [1] [2] Hardware-in-the-loop simulation is an aid to the development of new radar systems, which allows for testing and evaluation of the radar system earlier in the design cycle. This type of ...