Search results
Results from the WOW.Com Content Network
Unlike ATEX which uses numbers to define the safety "Category" of equipment (namely 1, 2, and 3), the IEC continued to utilise the method used for defining the safe levels of intrinsic safety namely "a" for zone 0, "b" for zone 1 and "c" for zone 2 and apply this Equipment Level of Protection to all equipment for use in hazardous areas since ...
This is a list of Superfund sites in Virginia designated under the Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA) environmental law.The CERCLA federal law of 1980 authorized the United States Environmental Protection Agency (EPA) to create a list of polluted locations requiring a long-term response to clean up hazardous material contaminations. [1]
Maximum experimental safe gap (MESG) is a standardized measurement of how easily a gas flame will pass through a narrow gap bordered by heat-absorbing metal. MESG is used to classify flammable gases for the design and/or selection of electrical equipment in hazardous areas, and flame arrestor devices. [1]
Intrinsic safety (IS) is a protection technique for safe operation of electrical equipment in hazardous areas by limiting the energy, electrical and thermal, available for ignition. In signal and control circuits that can operate with low currents and voltages, the intrinsic safety approach simplifies circuits and reduces installation cost over ...
There are four ATEX classifications to ensure that a specific piece of equipment or protective system is appropriate and can be safely used in a particular application: 1. Industrial or Mining Application 2. Equipment Category 3. Atmosphere 4. Temperature The ATEX as an EU directive finds its US equivalent under the HAZLOC standard.
The white "special notice" area can contain several symbols. The following symbols are defined by the NFPA 704 standard. OX: Oxidizer, allows chemicals to burn without an air supply (e.g., potassium perchlorate, ammonium nitrate, hydrogen peroxide). W: Reacts with water in an unusual or dangerous manner (e.g., caesium, sodium, diborane ...
Series 5 tests are used to determine if an article can be assigned to HD1.5 'Very Insensitive Explosive'; series 6 tests are used to determine the classification of an article within Hazard Divisions 1.1, 1.2, 1.3, or 1.4; and series 7 tests are used to determine if an article can be assigned to HD 1.6 as an article containing predominantly ...
The Schedule 1 list is one of three lists. Chemicals which are feasible to use as weapons, and their precursors, but which have legitimate applications as well are listed in Schedule 2 (small-scale applications) and Schedule 3 (large-scale applications).