Search results
Results from the WOW.Com Content Network
Although the nominal voltage of a 12 V lead acid battery is 12 V DC, when the engine is running the car's battery charging system will bring the system voltage to 13.8 V DC or higher. [10] The possible range of battery voltages from 11–15 V DC must be taken into account by devices attached to the cigar lighter socket.
In mobile networks, the terminal adapter is used by the terminal equipment to access the mobile termination, using AT commands (see Hayes command set). In 2G (such as GSM or CDMA), the terminal adapter is a theoretically optional while in 3G (such as W-CDMA), the terminal adapter is mandatory and is part of the mobile termination. [1]
They are also referred to as "pin & sleeve" connectors in North America [1] or as "CeeForm" connectors in the entertainment industry. [2] The maximum voltage allowed by the standard is 1000 V DC or AC; the maximum current, 800 A; and the maximum frequency, 500 Hz. The ambient temperature range is −25 °C to 40 °C. [3]
from 2nd battery and 12/24 V relay: 31 return to battery- or direct to ground 31a return to battery- 12/24 V relay 31b return to battery- or ground through switch 85d 31c return to battery- 12/24 V relay 31, 31a Electric motors; 32 return 31 33 main terminal (swap of 32 and 33 is possible) 30 33a limit 33b field 54e 33f 2. slow rpm: 33g 3. slow ...
Common battery contacts and terminals for smaller batteries. Battery terminals are the electrical contacts used to connect a load or charger to a single cell or multiple-cell battery. These terminals have a wide variety of designs, sizes, and features that are often not well documented.
A battery eliminator is an adapter intended to allow a device intended for battery operation, such as a radio, to be operated from an AC outlet. [10] All radios, except crystal sets, used inconvenient and messy vacuum tube batteries until the mid- to late-1920s. Battery eliminators that plugged into light sockets became very popular. [11]
The internal battery has its negative terminal wired to the sleeve contact of the jack. When the user plugs in a two-conductor (mono) plug, the resulting short circuit between the sleeve and ring connects an internal battery to the unit's circuitry, ensuring that it powers up or down automatically whenever a signal lead is inserted or removed.
Terminal symbol A terminal strip, to which wires can be soldered. A terminal is the point at which a conductor from a component, device or network comes to an end. [1] Terminal may also refer to an electrical connector at this endpoint, acting as the reusable interface to a conductor and creating a point where external circuits can be connected.