Search results
Results from the WOW.Com Content Network
400-pound tiger taken by Reverend H. R. Caldwell using a Savage 99 chambered for .22 Savage Hi-Power. The Model 99 and Model 1899 were preceded by the Model 1895, which was the first hammerless lever-action rifle. [13] The 1895, as well as the later Model 1899 and early Model 99, used a five-shot rotary magazine to hold the cartridges. [14]
For example, factory and aftermarket receivers using the Remington 700 footprint are produced with various types of action threads, all with a 26.99 mm (1 + 1 ⁄ 16 in) diameter, but with a pitch of either a 1.588 mm (16 TPI, Remington standard), 1.411 mm (18 TPI) or 1.270 mm (20 TPI, Savage standard).
The Savage 99 in Scientific American Volume 85 Number 10 (September 1901) Savage Arms Company - Utica, New York - 1904 Savage Arms Company - Rifles - Utica, New York - 1904. Savage Arms was founded in 1894 by Arthur Savage in Utica, New York. Within 20 years they were producing rifles, handguns, and ammunition. [1]
Casemate-mounted 5"/50 caliber gun on the USS North Dakota. A casemate is an armoured structure consisting of a static primary surface incorporating a limited-traverse gun mount: typically, this takes the form of either a gun mounted through a fixed armour plate (typically seen on tank destroyers and assault guns) or a mount consisting of a partial cylinder of armour "sandwiched" between ...
The mount is found on the left side of the rifle receiver, with machined cutouts for reduced weight and ease of installation; an example is the PSO-1 optical sight. Similar rails can also be found on rifles such as the Dragunov sniper rifle (SVD), the PSL rifle, the PKM as well as some AK series assault rifles from 1954 onwards. Since 1992 the ...
Among scopes for rail mounts, the 22.5-degree V-shaped Zeiss rail is the most prevalent standard. It was introduced in 1990. After the patent expired in 2008, compatible scopes have been offered from manufacturers such as Blaser, [1] Leica, Minox, Meopta, Nikon, [2] Noblex (formerly Docter [3]), Schmidt & Bender [4] and Steiner. [5]
It is similar in concept to the earlier commercial Weaver rail mount used to mount telescopic sights, but is taller and has wider slots at regular intervals along the entire length. The MIL-STD-1913 locking slot width is 0.206 in (5.23 mm). The spacing of slot centres is 0.394 in (10.01 mm) and the slot depth is 0.118 in (3.00 mm). [8]
The locking bar system allows for even stress to be distributed and prevent canting of the scope mount. Another form of scope canting is caused by the rings themselves. Many Weaver-type mounts, including many Picatinny-type scope rings and even the Redfield Type, have either two or four screws on top of the scope ring that hold the scope in place.