Search results
Results from the WOW.Com Content Network
ISO general purpose metric screw threads—Selected sizes for screws, bolts and nuts: V Thread Form ISO 724:1993: ISO general-purpose metric screw threads—Basic dimensions: V Thread Form ISO 725:2009: ISO inch screw threads—Basic dimensions: V Thread Form 51386 DIN 40400: Edison Thread: Round V Thread Form
The major diameter is given by 6p 1.2, [4]: 12 rounded to two significant figures in mm and the hex head size (across the flats) is 1.75 times the major diameter. BA sizes are specified by the following British Standards: BS 57:1951 — B.A. screws, bolts and nuts
Other (usually smaller) sizes may occur to reduce weight or cost, including the small series flange bolts defined in ISO 4162 which typically have hexagonal head sizes corresponding to the smaller 1st choice thread size (eg. M6 small series flange bolts have 8mm hexagonal heads, as would normally be found on M5 bolts). [10]
Abbreviations and acronyms for use on drawings and related documents Y14.4M–1989: Pictorial drawing Y14.41–2003: Digital product definition data practices Y14.42–2002: Digital approval systems Y14.5–2018: Dimensioning and tolerancing Y14.5.1M–1994: Mathematical definition of dimensioning and tolerancing principles Y14.6–2001
ISO Metric Trapezoidal Screw Threads; Limiting Sizes for Nut Threads from 8 to 100 mm Nominal Diameter: Active: DIN 103-6: ISO Metric Trapezoidal Screw Threads; Limiting Sizes for Nut Threads from 105 to 300 mm Nominal Diameter: Active: DIN 103-7: ISO Metric Trapezoidal Screw Threads; Limiting Sizes for Bolt Threads from 8 to 100 mm Nominal ...
Where the rotation of a shaft would cause a conventional right-handed nut to loosen rather than to tighten due to applied torque or to fretting induced precession. Examples include: The left foot pedal on a bicycle [2] The left grinding wheel on a bench grinder; The axle nuts, or less commonly, lug nuts on the left side of some automobiles
Even though #14 and #16 screws are still available, they are not as common as sizes #0 through #12. [citation needed] Sometimes "special" diameter and pitch combinations (UNS) are used, for example a 0.619 in (15.7 mm) major diameter with 20 threads per inch. UNS threads are rarely used for bolts, but rather on nuts, tapped holes, and threaded ODs.
Original file (SVG file, nominally 294 × 294 pixels, file size: 28 KB) This is a file from the Wikimedia Commons. ... Nut and Bolt identification markings. SAE and ...