Search results
Results from the WOW.Com Content Network
The most common wheel speed sensor system consists of a ferromagnetic toothed reluctor ring and a sensor (which can be passive or active). The tone wheel is typically made of steel and may be an open-air design, or sealed (as in the case of unitized bearing assemblies). The number of teeth is chosen as a trade-off between low-speed sensing ...
Most modern vehicles with automatic hubs, automatically lock their hubs when using low range gearbox, making it difficult or impossible to use torque multiplication in conjunction with FWD or RWD. Locking hub mechanisms also generally extend further beyond the wheel than most axles, and exposed hub locks can be broken or damaged by off-road ...
7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.
A wheel clamp, also known as wheel boot, parking boot, or Denver boot, [1] [2] is a device that is designed to prevent motor vehicles from being moved. In its most common form, it consists of a clamp that surrounds a vehicle wheel, designed to prevent removal of both itself and the wheel.
Kingpins were always clamped in the centre and the swivel bearings at the ends, to increase the lever arm and so reduce the bearing load. Independent front suspension developed through the 1930s, for high-performance cars at least, often using double wishbone suspension. This performance also encouraged the reduction of unsprung weight.
A ball bearing. A bearing is a machine element that constrains relative motion to only the desired motion and reduces friction between moving parts.The design of the bearing may, for example, provide for free linear movement of the moving part or for free rotation around a fixed axis; or, it may prevent a motion by controlling the vectors of normal forces that bear on the moving parts.
In 2000, a device called the "Club Buster" was designed for locksmiths. It is a big screw with a hook on one end and a large handle on the other and two legs designed to rest on the lock. It breaks steering wheel locks such as the Club by hooking onto the lock and tightening the screw with the handle.
A motorcycle fork connects a motorcycle's front wheel and axle to its frame, typically via a yoke, also known as a triple clamp, which consists of an upper yoke joined to a lower yoke via a steering stem, a shaft that runs through the steering head, creating the steering axis.