enow.com Web Search

  1. Ads

    related to: fast ethernet cable connector i to eal 3 wire

Search results

  1. Results from the WOW.Com Content Network
  2. Fast Ethernet - Wikipedia

    en.wikipedia.org/wiki/Fast_Ethernet

    100BASE-TX is the predominant form of Fast Ethernet, and runs over two pairs of wire inside a Category 5 or above cable. Cable distance between nodes can be up to 100 metres (328 ft). Cable distance between nodes can be up to 100 metres (328 ft).

  3. IEEE 802.3 - Wikipedia

    en.wikipedia.org/wiki/IEEE_802.3

    IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet. The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).

  4. Ethernet over twisted pair - Wikipedia

    en.wikipedia.org/wiki/Ethernet_over_twisted_pair

    Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. A cable for Ethernet may be wired to either the T568A or T568B termination standard at both ends of the cable. Since these standards differ only ...

  5. Category 3 cable - Wikipedia

    en.wikipedia.org/wiki/Category_3_cable

    A category 3 cable. Cat 3 was widely used in computer networking in the early 1990s for 10BASE-T Ethernet and, to a much lesser extent, for 100BaseVG Ethernet, Token Ring and 100BASE-T4. The original Power over Ethernet 802.3af specification supports the use of Cat 3 cable, but the later 802.3at Type 2 high-power variation does not. [8]

  6. Ethernet physical layer - Wikipedia

    en.wikipedia.org/wiki/Ethernet_physical_layer

    Ethernet physical layer; A standard 8P8C (often called RJ45) connector used most commonly on category 5 cable, one of the types of cabling used in Ethernet networks Standard IEEE 802.3 (1983 onwards) Physical media Twisted pair, optical fiber, coaxial cable Network topology Point-to-point, star, bus Major variants

  7. Attachment Unit Interface - Wikipedia

    en.wikipedia.org/wiki/Attachment_Unit_Interface

    An AUI connector is a DA-15 (D-subminiature) type, where the DTE side has a female connector and the MAU side has a male connector. [1]The connector often uses a sliding clip instead of the typical thumbscrews found on D-connectors, allowing the DTE and MAU to be directly attached, even when their size or shape would not accommodate thumbscrews.

  1. Ads

    related to: fast ethernet cable connector i to eal 3 wire